| Intro |
| ===== |
| |
| Andestech AE350 Platform |
| |
| The AE350 prototype demonstrates the AE350 platform on the FPGA. |
| |
| How to build it |
| =============== |
| |
| Configure Buildroot |
| ------------------- |
| |
| $ make andes_ae350_45_defconfig |
| |
| If you want to customize your configuration: |
| |
| $ make menuconfig |
| |
| Build everything |
| ---------------- |
| Note: you will need to access to the network, since Buildroot will |
| download the packages' sources. |
| |
| $ make |
| |
| Result of the build |
| ------------------- |
| |
| After building, you should obtain the following files: |
| |
| output/images/ |
| |-- ae350_ax45mp.dtb |
| |-- boot.vfat |
| |-- fw_dynamic.bin |
| |-- fw_dynamic.elf |
| |-- Image |
| |-- rootfs.ext2 |
| |-- rootfs.ext4 -> rootfs.ext2 |
| |-- sdcard.img |
| |-- u-boot-spl.bin |
| `-- u-boot.itb |
| |
| Copy the sdcard.img to a SD card with "dd": |
| |
| $ sudo dd if=sdcard.img of=/dev/sdX bs=4096 |
| $ sudo sync |
| |
| Your SD card partition should be: |
| |
| Disk /dev/sdb: 14.48 GiB, 15552479232 bytes, 30375936 sectors |
| Disk model: Multi-Card |
| Units: sectors of 1 * 512 = 512 bytes |
| Sector size (logical/physical): 512 bytes / 512 bytes |
| I/O size (minimum/optimal): 512 bytes / 512 bytes |
| Disklabel type: dos |
| Disk identifier: 0x00000000 |
| |
| Device Boot Start End Sectors Size Id Type |
| /dev/sdb1 1 4096 4096 2M c W95 FAT32 (LBA) |
| /dev/sdb2 * 4097 126976 122880 60M 83 Linux |
| |
| Insert SD card and reset the board, it should boot Linux from mmc. |
