Blackfin: gpio/ints: generalize pint logic
Have the logic that uses peripheral interrupt blocks key off of pint
defines rather than CPU names so that things are generalized across
families.
Signed-off-by: Mike Frysinger <vapier@gentoo.org>
diff --git a/arch/blackfin/mach-common/ints-priority.c b/arch/blackfin/mach-common/ints-priority.c
index 72ca67e..332dace 100644
--- a/arch/blackfin/mach-common/ints-priority.c
+++ b/arch/blackfin/mach-common/ints-priority.c
@@ -444,7 +444,7 @@
static DECLARE_BITMAP(gpio_enabled, MAX_BLACKFIN_GPIOS);
extern void bfin_gpio_irq_prepare(unsigned gpio);
-#if !defined(CONFIG_BF54x)
+#if !BFIN_GPIO_PINT
static void bfin_gpio_ack_irq(struct irq_data *d)
{
@@ -633,7 +633,7 @@
bfin_demux_gpio_block(irq);
}
-#else /* CONFIG_BF54x */
+#else
#define NR_PINT_SYS_IRQS 4
#define NR_PINT_BITS 32
@@ -968,7 +968,7 @@
local_irq_disable();
-#ifdef CONFIG_BF54x
+#if BFIN_GPIO_PINT
# ifdef CONFIG_PINTx_REASSIGN
pint[0]->assign = CONFIG_PINT0_ASSIGN;
pint[1]->assign = CONFIG_PINT1_ASSIGN;
@@ -986,16 +986,16 @@
irq_set_chip(irq, &bfin_internal_irqchip);
switch (irq) {
-#if defined(BF537_FAMILY)
- case IRQ_PH_INTA_MAC_RX:
- case IRQ_PF_INTA_PG_INTA:
-#elif defined(BF533_FAMILY)
- case IRQ_PROG_INTA:
-#elif defined(CONFIG_BF54x)
+#if BFIN_GPIO_PINT
case IRQ_PINT0:
case IRQ_PINT1:
case IRQ_PINT2:
case IRQ_PINT3:
+#elif defined(BF537_FAMILY)
+ case IRQ_PH_INTA_MAC_RX:
+ case IRQ_PF_INTA_PG_INTA:
+#elif defined(BF533_FAMILY)
+ case IRQ_PROG_INTA:
#elif defined(CONFIG_BF52x) || defined(CONFIG_BF51x)
case IRQ_PORTF_INTA:
case IRQ_PORTG_INTA:
