docs: i2c: i2c-protocol: remove unneeded colons from table
These colons are not needed: the columns already nicely separate the
symbols from their description. They are also inconsistently preceded by
whitespace.
Remove the colons completely to simplify and clean up.
Signed-off-by: Luca Ceresoli <luca@lucaceresoli.net>
Reviewed-by: Jean Delvare <jdelvare@suse.de>
Signed-off-by: Wolfram Sang <wsa@the-dreams.de>
diff --git a/Documentation/i2c/i2c-protocol.rst b/Documentation/i2c/i2c-protocol.rst
index c090003..66adac3 100644
--- a/Documentation/i2c/i2c-protocol.rst
+++ b/Documentation/i2c/i2c-protocol.rst
@@ -8,19 +8,19 @@
==============
=============== =============================================================
-S : Start condition
-P : Stop condition
-Rd/Wr (1 bit) : Read/Write bit. Rd equals 1, Wr equals 0.
-A, NA (1 bit) : Accept and reverse accept bit.
-Addr (7 bits): I2C 7 bit address. Note that this can be expanded as usual to
+S Start condition
+P Stop condition
+Rd/Wr (1 bit) Read/Write bit. Rd equals 1, Wr equals 0.
+A, NA (1 bit) Accept and reverse accept bit.
+Addr (7 bits) I2C 7 bit address. Note that this can be expanded as usual to
get a 10 bit I2C address.
-Comm (8 bits): Command byte, a data byte which often selects a register on
+Comm (8 bits) Command byte, a data byte which often selects a register on
the device.
-Data (8 bits): A plain data byte. Sometimes, I write DataLow, DataHigh
+Data (8 bits) A plain data byte. Sometimes, I write DataLow, DataHigh
for 16 bit data.
-Count (8 bits): A data byte containing the length of a block operation.
+Count (8 bits) A data byte containing the length of a block operation.
-[..]: Data sent by I2C device, as opposed to data sent by the
+[..] Data sent by I2C device, as opposed to data sent by the
host adapter.
=============== =============================================================
