ath10k: allocate fw resources for iface combinations
The number of 3 vdevs wasn't enough to handle the
worst case for interface combinations in practice.
wpa_supplicant may need up to 4 vifs to have 2
vifs actually connected, i.e. p2pdev + client + 2x
p2p (either p2p client or p2p go).
This fixes worst case warning:
Free vdev map is empty, no more interfaces allowed.
This keeps the ability to associate 32 stations in
AP mode at the cost of not being able to guarantee
that under all circumstances, i.e. some
combinations may consume additional fw peer
entries for internal purposes leaving less
resource for stations in AP mode.
Signed-off-by: Michal Kazior <michal.kazior@tieto.com>
Signed-off-by: Kalle Valo <kvalo@qca.qualcomm.com>
diff --git a/drivers/net/wireless/ath/ath10k/hw.h b/drivers/net/wireless/ath/ath10k/hw.h
index 2542159..89e09cb 100644
--- a/drivers/net/wireless/ath/ath10k/hw.h
+++ b/drivers/net/wireless/ath/ath10k/hw.h
@@ -299,11 +299,9 @@
#define TARGET_10_2_DMA_BURST_SIZE 1
/* Target specific defines for WMI-TLV firmware */
-#define TARGET_TLV_NUM_VDEVS 3
+#define TARGET_TLV_NUM_VDEVS 4
#define TARGET_TLV_NUM_STATIONS 32
-#define TARGET_TLV_NUM_PEERS ((TARGET_TLV_NUM_STATIONS) + \
- (TARGET_TLV_NUM_VDEVS) + \
- 2)
+#define TARGET_TLV_NUM_PEERS 35
#define TARGET_TLV_NUM_TDLS_VDEVS 1
#define TARGET_TLV_NUM_TIDS ((TARGET_TLV_NUM_PEERS) * 2)
#define TARGET_TLV_NUM_MSDU_DESC (1024 + 32)
diff --git a/drivers/net/wireless/ath/ath10k/wmi-tlv.c b/drivers/net/wireless/ath/ath10k/wmi-tlv.c
index 03e34c3..ae12078 100644
--- a/drivers/net/wireless/ath/ath10k/wmi-tlv.c
+++ b/drivers/net/wireless/ath/ath10k/wmi-tlv.c
@@ -1318,8 +1318,8 @@
cfg->num_peers = __cpu_to_le32(TARGET_TLV_NUM_PEERS);
if (test_bit(WMI_SERVICE_RX_FULL_REORDER, ar->wmi.svc_map)) {
- cfg->num_offload_peers = __cpu_to_le32(3);
- cfg->num_offload_reorder_bufs = __cpu_to_le32(3);
+ cfg->num_offload_peers = __cpu_to_le32(TARGET_TLV_NUM_VDEVS);
+ cfg->num_offload_reorder_bufs = __cpu_to_le32(TARGET_TLV_NUM_VDEVS);
} else {
cfg->num_offload_peers = __cpu_to_le32(0);
cfg->num_offload_reorder_bufs = __cpu_to_le32(0);
@@ -1336,8 +1336,8 @@
cfg->rx_timeout_pri[3] = __cpu_to_le32(0x28);
cfg->rx_decap_mode = __cpu_to_le32(1);
cfg->scan_max_pending_reqs = __cpu_to_le32(4);
- cfg->bmiss_offload_max_vdev = __cpu_to_le32(3);
- cfg->roam_offload_max_vdev = __cpu_to_le32(3);
+ cfg->bmiss_offload_max_vdev = __cpu_to_le32(TARGET_TLV_NUM_VDEVS);
+ cfg->roam_offload_max_vdev = __cpu_to_le32(TARGET_TLV_NUM_VDEVS);
cfg->roam_offload_max_ap_profiles = __cpu_to_le32(8);
cfg->num_mcast_groups = __cpu_to_le32(0);
cfg->num_mcast_table_elems = __cpu_to_le32(0);
