drm/i915/tgl: Fix TC-cold block/unblock sequence
The command register is the PCODE MBOX low register not the high one as
described by the spec. This left the system with the TC-cold power state
being blocked all the time. Fix things by using the correct register.
Also to make sure we retry a request for at least 600usec, when the
PCODE MBOX command itself succeeded, but the TC-cold block command
failed, sleep for 1msec unconditionally after any fail.
The change was tested with JTAG register read of the HW/FW's actual
TC-cold state, which reported the expected states after this change.
Tested-by: Nivedita Swaminathan <nivedita.swaminathan@intel.com>
Cc: José Roberto de Souza <jose.souza@intel.com>
Signed-off-by: Imre Deak <imre.deak@intel.com>
Reviewed-by: José Roberto de Souza <jose.souza@intel.com>
Link: https://patchwork.freedesktop.org/patch/msgid/20200805150056.24248-1-imre.deak@intel.com
Signed-off-by: Rodrigo Vivi <rodrigo.vivi@intel.com>
diff --git a/drivers/gpu/drm/i915/i915_reg.h b/drivers/gpu/drm/i915/i915_reg.h
index 2b403df..e85c6fc 100644
--- a/drivers/gpu/drm/i915/i915_reg.h
+++ b/drivers/gpu/drm/i915/i915_reg.h
@@ -9226,8 +9226,8 @@ enum {
#define DISPLAY_IPS_CONTROL 0x19
#define TGL_PCODE_TCCOLD 0x26
#define TGL_PCODE_EXIT_TCCOLD_DATA_L_EXIT_FAILED REG_BIT(0)
-#define TGL_PCODE_EXIT_TCCOLD_DATA_H_BLOCK_REQ 0
-#define TGL_PCODE_EXIT_TCCOLD_DATA_H_UNBLOCK_REQ REG_BIT(0)
+#define TGL_PCODE_EXIT_TCCOLD_DATA_L_BLOCK_REQ 0
+#define TGL_PCODE_EXIT_TCCOLD_DATA_L_UNBLOCK_REQ REG_BIT(0)
/* See also IPS_CTL */
#define IPS_PCODE_CONTROL (1 << 30)
#define HSW_PCODE_DYNAMIC_DUTY_CYCLE_CONTROL 0x1A
