diff --git a/drivers/usb/host/xhci-ring.c b/drivers/usb/host/xhci-ring.c
index 311597b..eaa49ae 100644
--- a/drivers/usb/host/xhci-ring.c
+++ b/drivers/usb/host/xhci-ring.c
@@ -366,7 +366,9 @@
 /* Must be called with xhci->lock held, releases and aquires lock back */
 static int xhci_abort_cmd_ring(struct xhci_hcd *xhci, unsigned long flags)
 {
-	u32 temp_32;
+	struct xhci_segment *new_seg	= xhci->cmd_ring->deq_seg;
+	union xhci_trb *new_deq		= xhci->cmd_ring->dequeue;
+	u64 crcr;
 	int ret;
 
 	xhci_dbg(xhci, "Abort command ring\n");
@@ -375,13 +377,18 @@
 
 	/*
 	 * The control bits like command stop, abort are located in lower
-	 * dword of the command ring control register. Limit the write
-	 * to the lower dword to avoid corrupting the command ring pointer
-	 * in case if the command ring is stopped by the time upper dword
-	 * is written.
+	 * dword of the command ring control register.
+	 * Some controllers require all 64 bits to be written to abort the ring.
+	 * Make sure the upper dword is valid, pointing to the next command,
+	 * avoiding corrupting the command ring pointer in case the command ring
+	 * is stopped by the time the upper dword is written.
 	 */
-	temp_32 = readl(&xhci->op_regs->cmd_ring);
-	writel(temp_32 | CMD_RING_ABORT, &xhci->op_regs->cmd_ring);
+	next_trb(xhci, NULL, &new_seg, &new_deq);
+	if (trb_is_link(new_deq))
+		next_trb(xhci, NULL, &new_seg, &new_deq);
+
+	crcr = xhci_trb_virt_to_dma(new_seg, new_deq);
+	xhci_write_64(xhci, crcr | CMD_RING_ABORT, &xhci->op_regs->cmd_ring);
 
 	/* Section 4.6.1.2 of xHCI 1.0 spec says software should also time the
 	 * completion of the Command Abort operation. If CRR is not negated in 5