qed*: Refactor mf_mode to consist of bits.
`mf_mode' field indicates the multi-partitioning mode the device is
configured to. This method doesn't scale very well, adding a new MF mode
requires going over all the existing conditions, and deciding whether those
are needed for the new mode or not.
The patch defines a set of bit-fields for modes which are derived according
to the mode info shared by the MFW and all the configuration would be made
according to those. To add a new mode, there would be a single place where
we'll need to go and choose which bits apply and which don't.
Signed-off-by: Sudarsana Reddy Kalluru <Sudarsana.Kalluru@cavium.com>
Signed-off-by: Ariel Elior <ariel.elior@cavium.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/ethernet/qlogic/qed/qed_ll2.c b/drivers/net/ethernet/qlogic/qed/qed_ll2.c
index 3850281..6c942c1 100644
--- a/drivers/net/ethernet/qlogic/qed/qed_ll2.c
+++ b/drivers/net/ethernet/qlogic/qed/qed_ll2.c
@@ -922,9 +922,9 @@ static int qed_sp_ll2_rx_queue_start(struct qed_hwfn *p_hwfn,
p_ramrod->queue_id = p_ll2_conn->queue_id;
p_ramrod->main_func_queue = p_ll2_conn->main_func_queue ? 1 : 0;
- if ((IS_MF_DEFAULT(p_hwfn) || IS_MF_SI(p_hwfn)) &&
- p_ramrod->main_func_queue && (conn_type != QED_LL2_TYPE_ROCE) &&
- (conn_type != QED_LL2_TYPE_IWARP)) {
+ if (test_bit(QED_MF_LL2_NON_UNICAST, &p_hwfn->cdev->mf_bits) &&
+ p_ramrod->main_func_queue && conn_type != QED_LL2_TYPE_ROCE &&
+ conn_type != QED_LL2_TYPE_IWARP) {
p_ramrod->mf_si_bcast_accept_all = 1;
p_ramrod->mf_si_mcast_accept_all = 1;
} else {
