Documentation/devicetree/bindings/spi/spi-mux.yaml

# SPDX-License-Identifier: (GPL-2.0 OR BSD-2-Clause)
%YAML 1.2
---
$id: http://devicetree.org/schemas/spi/spi-mux.yaml#
$schema: http://devicetree.org/meta-schemas/core.yaml#

title: Generic SPI Multiplexer

description: |
  This binding describes a SPI bus multiplexer to route the SPI chip select
  signals. This can be used when you need more devices than the SPI controller
  has chip selects available. An example setup is shown in ASCII art; the actual
  setting of the multiplexer to a channel needs to be done by a specific SPI mux
  driver.

        MOSI /--------------------------------+--------+--------+--------\
        MISO |/------------------------------+|-------+|-------+|-------\|
         SCL ||/----------------------------+||------+||------+||------\||
             |||                            |||      |||      |||      |||
      +------------+                        |||      |||      |||      |||
      | SoC  |||   |                      +-+++-+  +-+++-+  +-+++-+  +-+++-+
      |      |||   |                      | dev |  | dev |  | dev |  | dev |
      |   +--+++-+ | CS-X  +------+\      +--+--+  +--+--+  +--+--+  +--+--+
      |   | SPI  +-|-------+ Mux  |\\   CS-0 |        |        |        |
      |   +------+ |       +--+---+\\\-------/   CS-1 |        |        |
      |            |          |    \\\----------------/   CS-2 |        |
      |   +------+ |          |     \\-------------------------/   CS-3 |
      |   | ?    +-|----------/      \----------------------------------/
      |   +------+ |
      +------------+

allOf:
  - $ref: "/schemas/spi/spi-controller.yaml#"

maintainers:
  - Chris Packham <chris.packham@alliedtelesis.co.nz>

properties:
  compatible:
    const: spi-mux

  mux-controls:
    maxItems: 1

required:
  - compatible
  - reg
  - spi-max-frequency
  - mux-controls

unevaluatedProperties: false

examples:
  - |
    #include <dt-bindings/gpio/gpio.h>
    mux: mux-controller {
        compatible = "gpio-mux";
        #mux-control-cells = <0>;

        mux-gpios = <&gpio0 3 GPIO_ACTIVE_HIGH>;
    };

    spi {
        #address-cells = <1>;
        #size-cells = <0>;
        spi@0 {
            compatible = "spi-mux";
            reg = <0>;
            #address-cells = <1>;
            #size-cells = <0>;
            spi-max-frequency = <100000000>;

            mux-controls = <&mux>;

            flash@0 {
                compatible = "jedec,spi-nor";
                reg = <0>;
                spi-max-frequency = <40000000>;
            };

            sensor@1 {
                compatible = "bosch,bme680";
                reg = <1>;
                spi-max-frequency = <10000000>;
            };
        };
    };