Blackfin arch: rewrite our reboot code in C
rewrite our reboot code in C rather than assembly to be like
other architectures and to allow board maintainers to define
custom behavior
Signed-off-by: Mike Frysinger <michael.frysinger@analog.com>
Signed-off-by: Bryan Wu <bryan.wu@analog.com>
diff --git a/arch/blackfin/kernel/bfin_gpio.c b/arch/blackfin/kernel/bfin_gpio.c
index 0182ce1..d9284d7 100644
--- a/arch/blackfin/kernel/bfin_gpio.c
+++ b/arch/blackfin/kernel/bfin_gpio.c
@@ -80,6 +80,7 @@
* GPIO_47 PH15 PF47
*/
+#include <linux/delay.h>
#include <linux/module.h>
#include <linux/err.h>
#include <asm/blackfin.h>
@@ -888,3 +889,20 @@
local_irq_restore(flags);
}
EXPORT_SYMBOL(gpio_direction_output);
+
+/* If we are booting from SPI and our board lacks a strong enough pull up,
+ * the core can reset and execute the bootrom faster than the resistor can
+ * pull the signal logically high. To work around this (common) error in
+ * board design, we explicitly set the pin back to GPIO mode, force /CS
+ * high, and wait for the electrons to do their thing.
+ *
+ * This function only makes sense to be called from reset code, but it
+ * lives here as we need to force all the GPIO states w/out going through
+ * BUG() checks and such.
+ */
+void bfin_gpio_reset_spi0_ssel1(void)
+{
+ port_setup(P_SPI0_SSEL1, GPIO_USAGE);
+ gpio_bankb[gpio_bank(P_SPI0_SSEL1)]->data_set = gpio_bit(P_SPI0_SSEL1);
+ udelay(1);
+}
