| /* SPDX-License-Identifier: GPL-2.0 */ |
| /* |
| * Copyright (c) 2000-2008 LSI Corporation. All rights reserved. |
| * |
| * NAME: fc_log.h |
| * SUMMARY: MPI IocLogInfo definitions for the SYMFC9xx chips |
| * DESCRIPTION: Contains the enumerated list of values that may be returned |
| * in the IOCLogInfo field of a MPI Default Reply Message. |
| * |
| * CREATION DATE: 6/02/2000 |
| * ID: $Id: fc_log.h,v 4.6 2001/07/26 14:41:33 sschremm Exp $ |
| */ |
| |
| |
| /* |
| * MpiIocLogInfo_t enum |
| * |
| * These 32 bit values are used in the IOCLogInfo field of the MPI reply |
| * messages. |
| * The value is 0xabcccccc where |
| * a = The type of log info as per the MPI spec. Since these codes are |
| * all for Fibre Channel this value will always be 2. |
| * b = Specifies a subclass of the firmware where |
| * 0 = FCP Initiator |
| * 1 = FCP Target |
| * 2 = LAN |
| * 3 = MPI Message Layer |
| * 4 = FC Link |
| * 5 = Context Manager |
| * 6 = Invalid Field Offset |
| * 7 = State Change Info |
| * all others are reserved for future use |
| * c = A specific value within the subclass. |
| * |
| * NOTE: Any new values should be added to the end of each subclass so that the |
| * codes remain consistent across firmware releases. |
| */ |
| typedef enum _MpiIocLogInfoFc |
| { |
| MPI_IOCLOGINFO_FC_INIT_BASE = 0x20000000, |
| MPI_IOCLOGINFO_FC_INIT_ERROR_OUT_OF_ORDER_FRAME = 0x20000001, /* received an out of order frame - unsupported */ |
| MPI_IOCLOGINFO_FC_INIT_ERROR_BAD_START_OF_FRAME = 0x20000002, /* Bad Rx Frame, bad start of frame primitive */ |
| MPI_IOCLOGINFO_FC_INIT_ERROR_BAD_END_OF_FRAME = 0x20000003, /* Bad Rx Frame, bad end of frame primitive */ |
| MPI_IOCLOGINFO_FC_INIT_ERROR_OVER_RUN = 0x20000004, /* Bad Rx Frame, overrun */ |
| MPI_IOCLOGINFO_FC_INIT_ERROR_RX_OTHER = 0x20000005, /* Other errors caught by IOC which require retries */ |
| MPI_IOCLOGINFO_FC_INIT_ERROR_SUBPROC_DEAD = 0x20000006, /* Main processor could not initialize sub-processor */ |
| MPI_IOCLOGINFO_FC_INIT_ERROR_RX_OVERRUN = 0x20000007, /* Scatter Gather overrun */ |
| MPI_IOCLOGINFO_FC_INIT_ERROR_RX_BAD_STATUS = 0x20000008, /* Receiver detected context mismatch via invalid header */ |
| MPI_IOCLOGINFO_FC_INIT_ERROR_RX_UNEXPECTED_FRAME= 0x20000009, /* CtxMgr detected unsupported frame type */ |
| MPI_IOCLOGINFO_FC_INIT_ERROR_LINK_FAILURE = 0x2000000A, /* Link failure occurred */ |
| MPI_IOCLOGINFO_FC_INIT_ERROR_TX_TIMEOUT = 0x2000000B, /* Transmitter timeout error */ |
| |
| MPI_IOCLOGINFO_FC_TARGET_BASE = 0x21000000, |
| MPI_IOCLOGINFO_FC_TARGET_NO_PDISC = 0x21000001, /* not sent because we are waiting for a PDISC from the initiator */ |
| MPI_IOCLOGINFO_FC_TARGET_NO_LOGIN = 0x21000002, /* not sent because we are not logged in to the remote node */ |
| MPI_IOCLOGINFO_FC_TARGET_DOAR_KILLED_BY_LIP = 0x21000003, /* Data Out, Auto Response, not sent due to a LIP */ |
| MPI_IOCLOGINFO_FC_TARGET_DIAR_KILLED_BY_LIP = 0x21000004, /* Data In, Auto Response, not sent due to a LIP */ |
| MPI_IOCLOGINFO_FC_TARGET_DIAR_MISSING_DATA = 0x21000005, /* Data In, Auto Response, missing data frames */ |
| MPI_IOCLOGINFO_FC_TARGET_DONR_KILLED_BY_LIP = 0x21000006, /* Data Out, No Response, not sent due to a LIP */ |
| MPI_IOCLOGINFO_FC_TARGET_WRSP_KILLED_BY_LIP = 0x21000007, /* Auto-response after a write not sent due to a LIP */ |
| MPI_IOCLOGINFO_FC_TARGET_DINR_KILLED_BY_LIP = 0x21000008, /* Data In, No Response, not completed due to a LIP */ |
| MPI_IOCLOGINFO_FC_TARGET_DINR_MISSING_DATA = 0x21000009, /* Data In, No Response, missing data frames */ |
| MPI_IOCLOGINFO_FC_TARGET_MRSP_KILLED_BY_LIP = 0x2100000a, /* Manual Response not sent due to a LIP */ |
| MPI_IOCLOGINFO_FC_TARGET_NO_CLASS_3 = 0x2100000b, /* not sent because remote node does not support Class 3 */ |
| MPI_IOCLOGINFO_FC_TARGET_LOGIN_NOT_VALID = 0x2100000c, /* not sent because login to remote node not validated */ |
| MPI_IOCLOGINFO_FC_TARGET_FROM_OUTBOUND = 0x2100000e, /* cleared from the outbound queue after a logout */ |
| MPI_IOCLOGINFO_FC_TARGET_WAITING_FOR_DATA_IN = 0x2100000f, /* cleared waiting for data after a logout */ |
| |
| MPI_IOCLOGINFO_FC_LAN_BASE = 0x22000000, |
| MPI_IOCLOGINFO_FC_LAN_TRANS_SGL_MISSING = 0x22000001, /* Transaction Context Sgl Missing */ |
| MPI_IOCLOGINFO_FC_LAN_TRANS_WRONG_PLACE = 0x22000002, /* Transaction Context found before an EOB */ |
| MPI_IOCLOGINFO_FC_LAN_TRANS_RES_BITS_SET = 0x22000003, /* Transaction Context value has reserved bits set */ |
| MPI_IOCLOGINFO_FC_LAN_WRONG_SGL_FLAG = 0x22000004, /* Invalid SGL Flags */ |
| |
| MPI_IOCLOGINFO_FC_MSG_BASE = 0x23000000, |
| |
| MPI_IOCLOGINFO_FC_LINK_BASE = 0x24000000, |
| MPI_IOCLOGINFO_FC_LINK_LOOP_INIT_TIMEOUT = 0x24000001, /* Loop initialization timed out */ |
| MPI_IOCLOGINFO_FC_LINK_ALREADY_INITIALIZED = 0x24000002, /* Another system controller already initialized the loop */ |
| MPI_IOCLOGINFO_FC_LINK_LINK_NOT_ESTABLISHED = 0x24000003, /* Not synchronized to signal or still negotiating (possible cable problem) */ |
| MPI_IOCLOGINFO_FC_LINK_CRC_ERROR = 0x24000004, /* CRC check detected error on received frame */ |
| |
| MPI_IOCLOGINFO_FC_CTX_BASE = 0x25000000, |
| |
| MPI_IOCLOGINFO_FC_INVALID_FIELD_BYTE_OFFSET = 0x26000000, /* The lower 24 bits give the byte offset of the field in the request message that is invalid */ |
| MPI_IOCLOGINFO_FC_INVALID_FIELD_MAX_OFFSET = 0x26ffffff, |
| |
| MPI_IOCLOGINFO_FC_STATE_CHANGE = 0x27000000 /* The lower 24 bits give additional information concerning state change */ |
| |
| } MpiIocLogInfoFc_t; |
