[PATCH] Removed remaining PCI specific references from swiotlb.c
Matthew Wilcox pointed out that swiotlb.c implements a generic
interface that is not tied to just PCI. Remove includes of
<linux/pci.h>, <asm/pci.h>. Fix comments and printk() messages
to no longer refer to PCI.
Signed-off-by: Tony Luck <tony.luck@intel.com>
diff --git a/lib/swiotlb.c b/lib/swiotlb.c
index cae806d..c2fc470 100644
--- a/lib/swiotlb.c
+++ b/lib/swiotlb.c
@@ -17,17 +17,17 @@
*/
#include <linux/cache.h>
+#include <linux/dma-mapping.h>
#include <linux/mm.h>
#include <linux/module.h>
-#include <linux/pci.h>
#include <linux/spinlock.h>
#include <linux/string.h>
#include <linux/types.h>
#include <linux/ctype.h>
#include <asm/io.h>
-#include <asm/pci.h>
#include <asm/dma.h>
+#include <asm/scatterlist.h>
#include <linux/init.h>
#include <linux/bootmem.h>
@@ -127,7 +127,7 @@
/*
* Statically reserve bounce buffer space and initialize bounce buffer data
- * structures for the software IO TLB used to implement the PCI DMA API.
+ * structures for the software IO TLB used to implement the DMA API.
*/
void
swiotlb_init_with_default_size (size_t default_size)
@@ -502,24 +502,24 @@
/*
* Ran out of IOMMU space for this operation. This is very bad.
* Unfortunately the drivers cannot handle this operation properly.
- * unless they check for pci_dma_mapping_error (most don't)
+ * unless they check for dma_mapping_error (most don't)
* When the mapping is small enough return a static buffer to limit
* the damage, or panic when the transfer is too big.
*/
- printk(KERN_ERR "PCI-DMA: Out of SW-IOMMU space for %lu bytes at "
+ printk(KERN_ERR "DMA: Out of SW-IOMMU space for %lu bytes at "
"device %s\n", size, dev ? dev->bus_id : "?");
if (size > io_tlb_overflow && do_panic) {
- if (dir == PCI_DMA_FROMDEVICE || dir == PCI_DMA_BIDIRECTIONAL)
- panic("PCI-DMA: Memory would be corrupted\n");
- if (dir == PCI_DMA_TODEVICE || dir == PCI_DMA_BIDIRECTIONAL)
- panic("PCI-DMA: Random memory would be DMAed\n");
+ if (dir == DMA_FROM_DEVICE || dir == DMA_BIDIRECTIONAL)
+ panic("DMA: Memory would be corrupted\n");
+ if (dir == DMA_TO_DEVICE || dir == DMA_BIDIRECTIONAL)
+ panic("DMA: Random memory would be DMAed\n");
}
}
/*
* Map a single buffer of the indicated size for DMA in streaming mode. The
- * PCI address to use is returned.
+ * physical address to use is returned.
*
* Once the device is given the dma address, the device owns this memory until
* either swiotlb_unmap_single or swiotlb_dma_sync_single is performed.
@@ -606,8 +606,8 @@
* after a transfer.
*
* If you perform a swiotlb_map_single() but wish to interrogate the buffer
- * using the cpu, yet do not wish to teardown the PCI dma mapping, you must
- * call this function before doing so. At the next point you give the PCI dma
+ * using the cpu, yet do not wish to teardown the dma mapping, you must
+ * call this function before doing so. At the next point you give the dma
* address back to the card, you must first perform a
* swiotlb_dma_sync_for_device, and then the device again owns the buffer
*/
@@ -783,9 +783,9 @@
}
/*
- * Return whether the given PCI device DMA address mask can be supported
+ * Return whether the given device DMA address mask can be supported
* properly. For example, if your device can only drive the low 24-bits
- * during PCI bus mastering, then you would pass 0x00ffffff as the mask to
+ * during bus mastering, then you would pass 0x00ffffff as the mask to
* this function.
*/
int
