usb: gadget: allocate & giveback serial ports instead hard code them
This patch removes gserial_setup() and gserial_cleanup() and adds
gserial_alloc_line() and gserial_free_line() to replace them.
The initial setup of u_serial happens now on module load time. A
maximum of four TTY ports can be requested which is the current limit.
In theory we could extend this limit, the hard limit is the number of
available endpoints.
alloc_tty_driver() is now called at module init time with the max
available ports. The per-line footprint here is on 32bit is 3 * size of
pointer + 60 bytes (for cdevs).
The remaining memory (struct gs_port) is allocated once a port is
requested.
With this change it is possible to load g_multi and g_serial at the same
time. GS0 receives the module that is loaded first, GS1 is received by
the next module and so on. With the configfs interface the port number
can be exported and the device node is more predictable. Nothing changes
for g_serial and friends as long as one module is used.
Signed-off-by: Sebastian Andrzej Siewior <bigeasy@linutronix.de>
Signed-off-by: Felipe Balbi <balbi@ti.com>
diff --git a/drivers/usb/gadget/dbgp.c b/drivers/usb/gadget/dbgp.c
index 41eb98d..986fc51 100644
--- a/drivers/usb/gadget/dbgp.c
+++ b/drivers/usb/gadget/dbgp.c
@@ -231,6 +231,10 @@
gadget->ep0->driver_data = NULL;
}
+#ifdef CONFIG_USB_G_DBGP_SERIAL
+static unsigned char tty_line;
+#endif
+
static int __init dbgp_configure_endpoints(struct usb_gadget *gadget)
{
int stp;
@@ -268,7 +272,7 @@
dbgp.serial->in->desc = &i_desc;
dbgp.serial->out->desc = &o_desc;
- if (gserial_setup(gadget, 1) < 0) {
+ if (gserial_alloc_line(&tty_line)) {
stp = 3;
goto fail_3;
}
@@ -377,7 +381,7 @@
#ifdef CONFIG_USB_G_DBGP_PRINTK
err = dbgp_enable_ep();
#else
- err = gserial_connect(dbgp.serial, 0);
+ err = gserial_connect(dbgp.serial, tty_line);
#endif
if (err < 0)
goto fail;
@@ -420,7 +424,7 @@
{
usb_gadget_unregister_driver(&dbgp_driver);
#ifdef CONFIG_USB_G_DBGP_SERIAL
- gserial_cleanup();
+ gserial_free_line(tty_line);
#endif
}
