usb: dwc2/gadget: move phy bus legth initialization
This patch moves the part of code that initializes the PHY bus width.
This results in simpler code and removes the need to check whether
the Generic PHY Framework is used.
Signed-off-by: Kamil Debski <k.debski@samsung.com>
Signed-off-by: Marek Szyprowski <m.szyprowski@samsung.com>
Signed-off-by: Robert Baldyga <r.baldyga@samsung.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
diff --git a/drivers/usb/dwc2/gadget.c b/drivers/usb/dwc2/gadget.c
index 650a43b..94f7a3f 100644
--- a/drivers/usb/dwc2/gadget.c
+++ b/drivers/usb/dwc2/gadget.c
@@ -3423,6 +3423,9 @@
if (!hsotg)
return -ENOMEM;
+ /* Set default UTMI width */
+ hsotg->phyif = GUSBCFG_PHYIF16;
+
/*
* Attempt to find a generic PHY, then look for an old style
* USB PHY, finally fall back to pdata
@@ -3441,8 +3444,15 @@
hsotg->plat = plat;
} else
hsotg->uphy = uphy;
- } else
+ } else {
hsotg->phy = phy;
+ /*
+ * If using the generic PHY framework, check if the PHY bus
+ * width is 8-bit and set the phyif appropriately.
+ */
+ if (phy_get_bus_width(phy) == 8)
+ hsotg->phyif = GUSBCFG_PHYIF8;
+ }
hsotg->dev = dev;
@@ -3502,16 +3512,6 @@
goto err_supplies;
}
- /* Set default UTMI width */
- hsotg->phyif = GUSBCFG_PHYIF16;
-
- /*
- * If using the generic PHY framework, check if the PHY bus
- * width is 8-bit and set the phyif appropriately.
- */
- if (hsotg->phy && (phy_get_bus_width(phy) == 8))
- hsotg->phyif = GUSBCFG_PHYIF8;
-
/* usb phy enable */
s3c_hsotg_phy_enable(hsotg);
