powerpc: Add kconfig for muxed smp ipi support
Compile the new smp ipi mux and demux code only if a platform
will make use of it. The new config is selected as required.
The new cause_ipi smp op is only available conditionally to point out
configs where the select is required; this makes setting the op an
immediate fail instead of a deferred unresolved symbol at link.
This also creates a new config for power surge powermac upgrade support
that can be disabled in expert mode but is default on.
I also removed the depends / default y on CONFIG_XICS since it is selected
by PSERIES.
Signed-off-by: Milton Miller <miltonm@bga.com>
Signed-off-by: Benjamin Herrenschmidt <benh@kernel.crashing.org>
diff --git a/arch/powerpc/include/asm/smp.h b/arch/powerpc/include/asm/smp.h
index 26f8615..880b8c1 100644
--- a/arch/powerpc/include/asm/smp.h
+++ b/arch/powerpc/include/asm/smp.h
@@ -38,7 +38,9 @@
struct smp_ops_t {
void (*message_pass)(int cpu, int msg);
+#ifdef CONFIG_PPC_SMP_MUXED_IPI
void (*cause_ipi)(int cpu, unsigned long data);
+#endif
int (*probe)(void);
int (*kick_cpu)(int nr);
void (*setup_cpu)(int nr);
diff --git a/arch/powerpc/kernel/smp.c b/arch/powerpc/kernel/smp.c
index fa8e870..d76f7d7 100644
--- a/arch/powerpc/kernel/smp.c
+++ b/arch/powerpc/kernel/smp.c
@@ -178,6 +178,7 @@
return err;
}
+#ifdef CONFIG_PPC_SMP_MUXED_IPI
struct cpu_messages {
unsigned long messages; /* current messages bits */
unsigned long data; /* data for cause ipi */
@@ -230,6 +231,7 @@
}
return IRQ_HANDLED;
}
+#endif /* CONFIG_PPC_SMP_MUXED_IPI */
void smp_send_reschedule(int cpu)
{
diff --git a/arch/powerpc/platforms/Kconfig b/arch/powerpc/platforms/Kconfig
index 6059053..83c704a 100644
--- a/arch/powerpc/platforms/Kconfig
+++ b/arch/powerpc/platforms/Kconfig
@@ -57,6 +57,14 @@
depends on PPC_RTAS
default n
+config PPC_SMP_MUXED_IPI
+ bool
+ help
+ Select this opton if your platform supports SMP and your
+ interrupt controller provides less than 4 interrupts to each
+ cpu. This will enable the generic code to multiplex the 4
+ messages on to one ipi.
+
config PPC_UDBG_BEAT
bool "BEAT based debug console"
depends on PPC_CELLEB
diff --git a/arch/powerpc/platforms/Kconfig.cputype b/arch/powerpc/platforms/Kconfig.cputype
index a1e6238..2165b65 100644
--- a/arch/powerpc/platforms/Kconfig.cputype
+++ b/arch/powerpc/platforms/Kconfig.cputype
@@ -73,6 +73,7 @@
config PPC_BOOK3E_64
bool "Embedded processors"
select PPC_FPU # Make it a choice ?
+ select PPC_SMP_MUXED_IPI
endchoice
@@ -178,6 +179,7 @@
config PPC_FSL_BOOK3E
bool
select FSL_EMB_PERFMON
+ select PPC_SMP_MUXED_IPI
default y if FSL_BOOKE
config PTE_64BIT
diff --git a/arch/powerpc/platforms/iseries/Kconfig b/arch/powerpc/platforms/iseries/Kconfig
index ea1d362..b57cda3 100644
--- a/arch/powerpc/platforms/iseries/Kconfig
+++ b/arch/powerpc/platforms/iseries/Kconfig
@@ -1,6 +1,7 @@
config PPC_ISERIES
bool "IBM Legacy iSeries"
depends on PPC64 && PPC_BOOK3S
+ select PPC_SMP_MUXED_IPI
select PPC_INDIRECT_PIO
select PPC_INDIRECT_MMIO
select PPC_PCI_CHOICE if EXPERT
diff --git a/arch/powerpc/platforms/powermac/Kconfig b/arch/powerpc/platforms/powermac/Kconfig
index 1e1a087..1afd10f 100644
--- a/arch/powerpc/platforms/powermac/Kconfig
+++ b/arch/powerpc/platforms/powermac/Kconfig
@@ -18,4 +18,13 @@
select PPC_970_NAP
default y
-
+config PPC_PMAC32_PSURGE
+ bool "Support for powersurge upgrade cards" if EXPERT
+ depends on SMP && PPC32 && PPC_PMAC
+ select PPC_SMP_MUXED_IPI
+ default y
+ help
+ The powersurge cpu boards can be used in the generation
+ of powermacs that have a socket for an upgradeable cpu card,
+ including the 7500, 8500, 9500, 9600. Support exists for
+ both dual and quad socket upgrade cards.
diff --git a/arch/powerpc/platforms/powermac/pic.c b/arch/powerpc/platforms/powermac/pic.c
index 2f34ad0..b706cb3 100644
--- a/arch/powerpc/platforms/powermac/pic.c
+++ b/arch/powerpc/platforms/powermac/pic.c
@@ -239,7 +239,7 @@
unsigned long bits = 0;
unsigned long flags;
-#ifdef CONFIG_SMP
+#ifdef CONFIG_PPC_PMAC32_PSURGE
void psurge_smp_message_recv(void);
/* IPI's are a hack on the powersurge -- Cort */
@@ -247,7 +247,7 @@
psurge_smp_message_recv();
return NO_IRQ_IGNORE; /* ignore, already handled */
}
-#endif /* CONFIG_SMP */
+#endif /* CONFIG_PPC_PMAC32_PSURGE */
raw_spin_lock_irqsave(&pmac_pic_lock, flags);
for (irq = max_real_irqs; (irq -= 32) >= 0; ) {
int i = irq >> 5;
diff --git a/arch/powerpc/platforms/powermac/smp.c b/arch/powerpc/platforms/powermac/smp.c
index a340107..67b6e14 100644
--- a/arch/powerpc/platforms/powermac/smp.c
+++ b/arch/powerpc/platforms/powermac/smp.c
@@ -70,7 +70,7 @@
static u64 timebase;
static int tb_req;
-#ifdef CONFIG_PPC32
+#ifdef CONFIG_PPC_PMAC32_PSURGE
/*
* Powersurge (old powermac SMP) support.
@@ -420,7 +420,7 @@
.give_timebase = smp_psurge_give_timebase,
.take_timebase = smp_psurge_take_timebase,
};
-#endif /* CONFIG_PPC32 - actually powersurge support */
+#endif /* CONFIG_PPC_PMAC32_PSURGE */
/*
* Core 99 and later support
@@ -980,7 +980,7 @@
of_node_put(np);
smp_ops = &core99_smp_ops;
}
-#ifdef CONFIG_PPC32
+#ifdef CONFIG_PPC_PMAC32_PSURGE
else {
/* We have to set bits in cpu_possible_mask here since the
* secondary CPU(s) aren't in the device tree. Various
@@ -993,7 +993,7 @@
set_cpu_possible(cpu, true);
smp_ops = &psurge_smp_ops;
}
-#endif /* CONFIG_PPC32 */
+#endif /* CONFIG_PPC_PMAC32_PSURGE */
#ifdef CONFIG_HOTPLUG_CPU
ppc_md.cpu_die = pmac_cpu_die;
diff --git a/arch/powerpc/sysdev/xics/Kconfig b/arch/powerpc/sysdev/xics/Kconfig
index 123b8dd..0031eda 100644
--- a/arch/powerpc/sysdev/xics/Kconfig
+++ b/arch/powerpc/sysdev/xics/Kconfig
@@ -1,5 +1,6 @@
config PPC_XICS
def_bool n
+ select PPC_SMP_MUXED_IPI
config PPC_ICP_NATIVE
def_bool n
