#
# QLogic network device configuration
#

config NET_VENDOR_QLOGIC
	bool "QLogic devices"
	default y
	depends on PCI
	---help---
	  If you have a network (Ethernet) card belonging to this class, say Y.

	  Note that the answer to this question doesn't directly affect the
	  kernel: saying N will just cause the configurator to skip all
	  the questions about QLogic cards. If you say Y, you will be asked for
	  your specific card in the following questions.

if NET_VENDOR_QLOGIC

config QLA3XXX
	tristate "QLogic QLA3XXX Network Driver Support"
	depends on PCI
	---help---
	  This driver supports QLogic ISP3XXX gigabit Ethernet cards.

	  To compile this driver as a module, choose M here: the module
	  will be called qla3xxx.

config QLCNIC
	tristate "QLOGIC QLCNIC 1/10Gb Converged Ethernet NIC Support"
	depends on PCI
	select FW_LOADER
	---help---
	  This driver supports QLogic QLE8240 and QLE8242 Converged Ethernet
	  devices.

config QLCNIC_SRIOV
	bool "QLOGIC QLCNIC 83XX family SR-IOV Support"
	depends on QLCNIC && PCI_IOV
	default y
	---help---
	  This configuration parameter enables Single Root Input Output
	  Virtualization support for QLE83XX Converged Ethernet devices.
	  This allows for virtual function acceleration in virtualized
	  environments.

config QLCNIC_DCB
	bool "QLOGIC QLCNIC 82XX and 83XX family DCB Support"
	depends on QLCNIC && DCB
	default y
	---help---
	  This configuration parameter enables DCB support in QLE83XX
	  and QLE82XX Converged Ethernet devices. This allows for DCB
	  get operations support through rtNetlink interface. Only CEE
	  mode of DCB is supported. PG and PFC values are related only
	  to Tx.

config QLCNIC_VXLAN
	bool "Virtual eXtensible Local Area Network (VXLAN) offload support"
	default n
	depends on QLCNIC && VXLAN && !(QLCNIC=y && VXLAN=m)
	---help---
	  This enables hardware offload support for VXLAN protocol over QLogic's
	  84XX series adapters.
	  Say Y here if you want to enable hardware offload support for
	  Virtual eXtensible Local Area Network (VXLAN) in the driver.

config QLCNIC_HWMON
	bool "QLOGIC QLCNIC 82XX and 83XX family HWMON support"
	depends on QLCNIC && HWMON && !(QLCNIC=y && HWMON=m)
	default y
	---help---
	  This configuration parameter can be used to read the
	  board temperature in Converged Ethernet devices
	  supported by qlcnic.

	  This data is available via the hwmon sysfs interface.

config QLGE
	tristate "QLogic QLGE 10Gb Ethernet Driver Support"
	depends on PCI
	---help---
	  This driver supports QLogic ISP8XXX 10Gb Ethernet cards.

	  To compile this driver as a module, choose M here: the module
	  will be called qlge.

config NETXEN_NIC
	tristate "NetXen Multi port (1/10) Gigabit Ethernet NIC"
	depends on PCI
	select FW_LOADER
	---help---
	  This enables the support for NetXen's Gigabit Ethernet card.

endif # NET_VENDOR_QLOGIC