PM / OPP: Remove unused parameter of _generic_set_opp_clk_only()
The previous frequency value isn't getting used in the routine
_generic_set_opp_clk_only(), drop it.
Reviewed-by: Stephen Boyd <sboyd@kernel.org>
Signed-off-by: Viresh Kumar <viresh.kumar@linaro.org>
diff --git a/drivers/opp/core.c b/drivers/opp/core.c
index e5507ad..57d88a2 100644
--- a/drivers/opp/core.c
+++ b/drivers/opp/core.c
@@ -533,9 +533,8 @@ static int _set_opp_voltage(struct device *dev, struct regulator *reg,
return ret;
}
-static inline int
-_generic_set_opp_clk_only(struct device *dev, struct clk *clk,
- unsigned long old_freq, unsigned long freq)
+static inline int _generic_set_opp_clk_only(struct device *dev, struct clk *clk,
+ unsigned long freq)
{
int ret;
@@ -572,7 +571,7 @@ static int _generic_set_opp_regulator(const struct opp_table *opp_table,
}
/* Change frequency */
- ret = _generic_set_opp_clk_only(dev, opp_table->clk, old_freq, freq);
+ ret = _generic_set_opp_clk_only(dev, opp_table->clk, freq);
if (ret)
goto restore_voltage;
@@ -586,7 +585,7 @@ static int _generic_set_opp_regulator(const struct opp_table *opp_table,
return 0;
restore_freq:
- if (_generic_set_opp_clk_only(dev, opp_table->clk, freq, old_freq))
+ if (_generic_set_opp_clk_only(dev, opp_table->clk, old_freq))
dev_err(dev, "%s: failed to restore old-freq (%lu Hz)\n",
__func__, old_freq);
restore_voltage:
@@ -759,7 +758,7 @@ int dev_pm_opp_set_rate(struct device *dev, unsigned long target_freq)
opp->supplies);
} else {
/* Only frequency scaling */
- ret = _generic_set_opp_clk_only(dev, clk, old_freq, freq);
+ ret = _generic_set_opp_clk_only(dev, clk, freq);
}
/* Scaling down? Configure required OPPs after frequency */
