sky2: Enable/disable WOL per hardware device
Y2_HW_WOL_ON/Y2_HW_WOL_OFF should be set and cleared per chip,
not per port. On dual port cards, Y2_HW_WOL_ON should be
enabled if either sky2 port has WOL enabled.
Found while reviewing code for a WOL regression, though this is
probably not the cause of the regression.
Signed-off-by: Mike McCormack <mikem@ring3k.org>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/sky2.c b/drivers/net/sky2.c
index 37f486b..02d0b42 100644
--- a/drivers/net/sky2.c
+++ b/drivers/net/sky2.c
@@ -3228,6 +3228,27 @@
return sky2_is_copper(hw) ? (WAKE_PHY | WAKE_MAGIC) : 0;
}
+static void sky2_hw_set_wol(struct sky2_hw *hw)
+{
+ int wol = 0;
+ int i;
+
+ for (i = 0; i < hw->ports; i++) {
+ struct net_device *dev = hw->dev[i];
+ struct sky2_port *sky2 = netdev_priv(dev);
+
+ if (sky2->wol)
+ wol = 1;
+ }
+
+ if (hw->chip_id == CHIP_ID_YUKON_EC_U ||
+ hw->chip_id == CHIP_ID_YUKON_EX ||
+ hw->chip_id == CHIP_ID_YUKON_FE_P)
+ sky2_write32(hw, B0_CTST, wol ? Y2_HW_WOL_ON : Y2_HW_WOL_OFF);
+
+ device_set_wakeup_enable(&hw->pdev->dev, wol);
+}
+
static void sky2_get_wol(struct net_device *dev, struct ethtool_wolinfo *wol)
{
const struct sky2_port *sky2 = netdev_priv(dev);
@@ -3247,13 +3268,7 @@
sky2->wol = wol->wolopts;
- if (hw->chip_id == CHIP_ID_YUKON_EC_U ||
- hw->chip_id == CHIP_ID_YUKON_EX ||
- hw->chip_id == CHIP_ID_YUKON_FE_P)
- sky2_write32(hw, B0_CTST, sky2->wol
- ? Y2_HW_WOL_ON : Y2_HW_WOL_OFF);
-
- device_set_wakeup_enable(&hw->pdev->dev, sky2->wol);
+ sky2_hw_set_wol(hw);
if (!netif_running(dev))
sky2_wol_init(sky2);
