blob: 49e8530ca0ac8d156f7407416d51033e210e31e2 [file] [log] [blame]
# SPDX-License-Identifier: GPL-2.0-only
config WILCO_EC
tristate "ChromeOS Wilco Embedded Controller"
depends on X86 || COMPILE_TEST
depends on ACPI && CROS_EC_LPC && LEDS_CLASS
help
If you say Y here, you get support for talking to the ChromeOS
Wilco EC over an eSPI bus. This uses a simple byte-level protocol
with a checksum.
To compile this driver as a module, choose M here: the
module will be called wilco_ec.
config WILCO_EC_DEBUGFS
tristate "Enable raw access to EC via debugfs"
depends on WILCO_EC
help
If you say Y here, you get support for sending raw commands to
the Wilco EC via debugfs. These commands do not do any byte
manipulation and allow for testing arbitrary commands. This
interface is intended for debug only and will not be present
on production devices.
config WILCO_EC_EVENTS
tristate "Enable event forwarding from EC to userspace"
depends on WILCO_EC
help
If you say Y here, you get support for the EC to send events
(such as power state changes) to userspace. The EC sends the events
over ACPI, and a driver queues up the events to be read by a
userspace daemon from /dev/wilco_event using read() and poll().
config WILCO_EC_TELEMETRY
tristate "Enable querying telemetry data from EC"
depends on WILCO_EC
help
If you say Y here, you get support to query EC telemetry data from
/dev/wilco_telem0 using write() and then read().