scsi: storvsc: Always set no_report_opcodes
Hyper-V synthetic SCSI devices do not support the MAINTENANCE_IN SCSI
command, so scsi_report_opcode() always fails, resulting in messages like
this:
hv_storvsc <guid>: tag#205 cmd 0xa3 status: scsi 0x2 srb 0x86 hv 0xc0000001
The recently added support for command duration limits calls
scsi_report_opcode() four times as each device comes online, which
significantly increases the number of messages logged in a system with many
disks.
Fix the problem by always marking Hyper-V synthetic SCSI devices as not
supporting scsi_report_opcode(). With this setting, the MAINTENANCE_IN SCSI
command is not issued and no messages are logged.
Signed-off-by: Michael Kelley <mikelley@microsoft.com>
Link: https://lore.kernel.org/r/1686343101-18930-1-git-send-email-mikelley@microsoft.com
Signed-off-by: Martin K. Petersen <martin.petersen@oracle.com>
diff --git a/drivers/scsi/storvsc_drv.c b/drivers/scsi/storvsc_drv.c
index e6bc622..659196a 100644
--- a/drivers/scsi/storvsc_drv.c
+++ b/drivers/scsi/storvsc_drv.c
@@ -1567,6 +1567,8 @@ static int storvsc_device_configure(struct scsi_device *sdevice)
{
blk_queue_rq_timeout(sdevice->request_queue, (storvsc_timeout * HZ));
+ /* storvsc devices don't support MAINTENANCE_IN SCSI cmd */
+ sdevice->no_report_opcodes = 1;
sdevice->no_write_same = 1;
/*
