gfs2: Improve mmap write vs. punch_hole consistency
When punching a hole in a file, use filemap_write_and_wait_range to
write back any dirty pages in the range of the hole. As a side effect,
if the hole isn't page aligned, this marks unaligned pages at the
beginning and the end of the hole read-only. This is required when the
block size is smaller than the page size: when those pages are written
to again after the hole punching, we must make sure that page_mkwrite is
called for those pages so that the page will be fully allocated and any
blocks turned into holes from the hole punching will be reallocated.
(If a page is writably mapped, page_mkwrite won't be called.)
Fixes xfstest generic/567.
Signed-off-by: Andreas Gruenbacher <agruenba@redhat.com>
diff --git a/fs/gfs2/bmap.c b/fs/gfs2/bmap.c
index f63df54..bb0113a 100644
--- a/fs/gfs2/bmap.c
+++ b/fs/gfs2/bmap.c
@@ -2440,8 +2440,16 @@ int __gfs2_punch_hole(struct file *file, loff_t offset, loff_t length)
struct inode *inode = file_inode(file);
struct gfs2_inode *ip = GFS2_I(inode);
struct gfs2_sbd *sdp = GFS2_SB(inode);
+ unsigned int blocksize = i_blocksize(inode);
+ loff_t start, end;
int error;
+ start = round_down(offset, blocksize);
+ end = round_up(offset + length, blocksize) - 1;
+ error = filemap_write_and_wait_range(inode->i_mapping, start, end);
+ if (error)
+ return error;
+
if (gfs2_is_jdata(ip))
error = gfs2_trans_begin(sdp, RES_DINODE + 2 * RES_JDATA,
GFS2_JTRUNC_REVOKES);
@@ -2455,9 +2463,8 @@ int __gfs2_punch_hole(struct file *file, loff_t offset, loff_t length)
if (error)
goto out;
} else {
- unsigned int start_off, end_len, blocksize;
+ unsigned int start_off, end_len;
- blocksize = i_blocksize(inode);
start_off = offset & (blocksize - 1);
end_len = (offset + length) & (blocksize - 1);
if (start_off) {
