| // SPDX-License-Identifier: GPL-2.0 |
| /* Copyright(c) 2009-2012 Realtek Corporation.*/ |
| |
| #include "../wifi.h" |
| #include "../pci.h" |
| #include "../rtl8192d/reg.h" |
| #include "led.h" |
| |
| void rtl92de_sw_led_on(struct ieee80211_hw *hw, enum rtl_led_pin pin) |
| { |
| u8 ledcfg; |
| struct rtl_priv *rtlpriv = rtl_priv(hw); |
| |
| rtl_dbg(rtlpriv, COMP_LED, DBG_LOUD, "LedAddr:%X ledpin=%d\n", |
| REG_LEDCFG2, pin); |
| |
| switch (pin) { |
| case LED_PIN_GPIO0: |
| break; |
| case LED_PIN_LED0: |
| ledcfg = rtl_read_byte(rtlpriv, REG_LEDCFG2); |
| |
| if ((rtlpriv->efuse.eeprom_did == 0x8176) || |
| (rtlpriv->efuse.eeprom_did == 0x8193)) |
| /* BIT7 of REG_LEDCFG2 should be set to |
| * make sure we could emit the led2. */ |
| rtl_write_byte(rtlpriv, REG_LEDCFG2, (ledcfg & 0xf0) | |
| BIT(7) | BIT(5) | BIT(6)); |
| else |
| rtl_write_byte(rtlpriv, REG_LEDCFG2, (ledcfg & 0xf0) | |
| BIT(7) | BIT(5)); |
| break; |
| case LED_PIN_LED1: |
| ledcfg = rtl_read_byte(rtlpriv, REG_LEDCFG1); |
| |
| rtl_write_byte(rtlpriv, REG_LEDCFG2, (ledcfg & 0x0f) | BIT(5)); |
| break; |
| default: |
| pr_err("switch case %#x not processed\n", pin); |
| break; |
| } |
| } |
| |
| void rtl92de_sw_led_off(struct ieee80211_hw *hw, enum rtl_led_pin pin) |
| { |
| struct rtl_priv *rtlpriv = rtl_priv(hw); |
| u8 ledcfg; |
| |
| rtl_dbg(rtlpriv, COMP_LED, DBG_LOUD, "LedAddr:%X ledpin=%d\n", |
| REG_LEDCFG2, pin); |
| |
| ledcfg = rtl_read_byte(rtlpriv, REG_LEDCFG2); |
| |
| switch (pin) { |
| case LED_PIN_GPIO0: |
| break; |
| case LED_PIN_LED0: |
| ledcfg &= 0xf0; |
| if (rtlpriv->ledctl.led_opendrain) |
| rtl_write_byte(rtlpriv, REG_LEDCFG2, |
| (ledcfg | BIT(1) | BIT(5) | BIT(6))); |
| else |
| rtl_write_byte(rtlpriv, REG_LEDCFG2, |
| (ledcfg | BIT(3) | BIT(5) | BIT(6))); |
| break; |
| case LED_PIN_LED1: |
| ledcfg &= 0x0f; |
| rtl_write_byte(rtlpriv, REG_LEDCFG2, (ledcfg | BIT(3))); |
| break; |
| default: |
| pr_err("switch case %#x not processed\n", pin); |
| break; |
| } |
| } |
| |
| static void _rtl92ce_sw_led_control(struct ieee80211_hw *hw, |
| enum led_ctl_mode ledaction) |
| { |
| struct rtl_priv *rtlpriv = rtl_priv(hw); |
| enum rtl_led_pin pin0 = rtlpriv->ledctl.sw_led0; |
| |
| switch (ledaction) { |
| case LED_CTL_POWER_ON: |
| case LED_CTL_LINK: |
| case LED_CTL_NO_LINK: |
| rtl92de_sw_led_on(hw, pin0); |
| break; |
| case LED_CTL_POWER_OFF: |
| rtl92de_sw_led_off(hw, pin0); |
| break; |
| default: |
| break; |
| } |
| } |
| |
| void rtl92de_led_control(struct ieee80211_hw *hw, enum led_ctl_mode ledaction) |
| { |
| struct rtl_priv *rtlpriv = rtl_priv(hw); |
| struct rtl_ps_ctl *ppsc = rtl_psc(rtl_priv(hw)); |
| |
| if ((ppsc->rfoff_reason > RF_CHANGE_BY_PS) && |
| (ledaction == LED_CTL_TX || |
| ledaction == LED_CTL_RX || |
| ledaction == LED_CTL_SITE_SURVEY || |
| ledaction == LED_CTL_LINK || |
| ledaction == LED_CTL_NO_LINK || |
| ledaction == LED_CTL_START_TO_LINK || |
| ledaction == LED_CTL_POWER_ON)) { |
| return; |
| } |
| rtl_dbg(rtlpriv, COMP_LED, DBG_LOUD, "ledaction %d,\n", ledaction); |
| |
| _rtl92ce_sw_led_control(hw, ledaction); |
| } |