drivers: Defer probe if firmware is not ready
Driver needs ZynqMP firmware interface to call EEMI
APIs. In case firmware is not ready, dependent drivers
should wait until the firmware is ready.
Signed-off-by: Rajan Vaja <rajan.vaja@xilinx.com>
Signed-off-by: Jolly Shah <jollys@xilinx.com>
Signed-off-by: Michal Simek <michal.simek@xilinx.com>
diff --git a/drivers/reset/reset-zynqmp.c b/drivers/reset/reset-zynqmp.c
index 2ef1f13..99e75d9 100644
--- a/drivers/reset/reset-zynqmp.c
+++ b/drivers/reset/reset-zynqmp.c
@@ -79,11 +79,11 @@ static int zynqmp_reset_probe(struct platform_device *pdev)
if (!priv)
return -ENOMEM;
- platform_set_drvdata(pdev, priv);
-
priv->eemi_ops = zynqmp_pm_get_eemi_ops();
- if (!priv->eemi_ops)
- return -ENXIO;
+ if (IS_ERR(priv->eemi_ops))
+ return PTR_ERR(priv->eemi_ops);
+
+ platform_set_drvdata(pdev, priv);
priv->rcdev.ops = &zynqmp_reset_ops;
priv->rcdev.owner = THIS_MODULE;
