mmc: meson-gx: fix rx phase reset
Resetting the phase when POWER_ON is set the set_ios() call means that the
phase is reset almost every time the set_ios() is called, while the
expected behavior was to reset the phase on a power cycle.
This had gone unnoticed until now because in all mode (except hs400) the
tuning is done after the last to set_ios(). In such case, the tuning
result is used anyway. In HS400, there are a few calls to set_ios() after
the tuning is done, overwriting the tuning result.
Resetting the phase on POWER_UP instead of POWER_ON solve the problem.
Fixes: d341ca88eead ("mmc: meson-gx: rework tuning function")
Signed-off-by: Jerome Brunet <jbrunet@baylibre.com>
Reviewed-by: Kevin Hilman <khilman@baylibre.com>
Signed-off-by: Ulf Hansson <ulf.hansson@linaro.org>
diff --git a/drivers/mmc/host/meson-gx-mmc.c b/drivers/mmc/host/meson-gx-mmc.c
index 421c871..08a55c2 100644
--- a/drivers/mmc/host/meson-gx-mmc.c
+++ b/drivers/mmc/host/meson-gx-mmc.c
@@ -745,6 +745,10 @@ static void meson_mmc_set_ios(struct mmc_host *mmc, struct mmc_ios *ios)
case MMC_POWER_UP:
if (!IS_ERR(mmc->supply.vmmc))
mmc_regulator_set_ocr(mmc, mmc->supply.vmmc, ios->vdd);
+
+ /* Reset rx phase */
+ clk_set_phase(host->rx_clk, 0);
+
break;
case MMC_POWER_ON:
@@ -758,8 +762,6 @@ static void meson_mmc_set_ios(struct mmc_host *mmc, struct mmc_ios *ios)
host->vqmmc_enabled = true;
}
- /* Reset rx phase */
- clk_set_phase(host->rx_clk, 0);
break;
}
