[SCSI] use scmd_id(), scmd_channel() throughout code
Wrap a highly common idiom. Makes the code easier to read, helps pave
the way for sdev->{id,channel} removal, and adds a token that can easily
by grepped-for in the future.
There are a couple sdev_id() and scmd_printk() updates thrown in as well.
Rejections fixed up and
Signed-off-by: James Bottomley <James.Bottomley@SteelEye.com>
diff --git a/drivers/scsi/nsp32.c b/drivers/scsi/nsp32.c
index 6367f00..e4ff4f0 100644
--- a/drivers/scsi/nsp32.c
+++ b/drivers/scsi/nsp32.c
@@ -481,7 +481,7 @@
nsp32_hw_data *data = (nsp32_hw_data *)SCpnt->device->host->hostdata;
unsigned int base = SCpnt->device->host->io_port;
unsigned int host_id = SCpnt->device->host->this_id;
- unsigned char target = SCpnt->device->id;
+ unsigned char target = scmd_id(SCpnt);
nsp32_autoparam *param = data->autoparam;
unsigned char phase;
int i, ret;
@@ -612,7 +612,7 @@
nsp32_hw_data *data = (nsp32_hw_data *)SCpnt->device->host->hostdata;
unsigned int base = SCpnt->device->host->io_port;
unsigned int host_id = SCpnt->device->host->this_id;
- unsigned char target = SCpnt->device->id;
+ unsigned char target = scmd_id(SCpnt);
unsigned char phase;
int status;
unsigned short command = 0;
@@ -973,7 +973,7 @@
}
/* check target ID is not same as this initiator ID */
- if (SCpnt->device->id == SCpnt->device->host->this_id) {
+ if (scmd_id(SCpnt) == SCpnt->device->host->this_id) {
nsp32_dbg(NSP32_DEBUG_QUEUECOMMAND, "terget==host???");
SCpnt->result = DID_BAD_TARGET << 16;
done(SCpnt);
@@ -1028,7 +1028,7 @@
* (target don't have SDTR_DONE and SDTR_INITIATOR), sync
* message SDTR is needed to do synchronous transfer.
*/
- target = &data->target[SCpnt->device->id];
+ target = &data->target[scmd_id(SCpnt)];
data->cur_target = target;
if (!(target->sync_flag & (SDTR_DONE | SDTR_INITIATOR | SDTR_TARGET))) {
