blob: e74bbc9c78597f3425820b1760ada7efc37d6f91 [file] [log] [blame]
// SPDX-License-Identifier: GPL-2.0+
/*
* Voltage regulators coupler for NVIDIA Tegra30
* Copyright (C) 2019 GRATE-DRIVER project
*
* Voltage constraints borrowed from downstream kernel sources
* Copyright (C) 2010-2011 NVIDIA Corporation
*/
#define pr_fmt(fmt) "tegra voltage-coupler: " fmt
#include <linux/init.h>
#include <linux/kernel.h>
#include <linux/of.h>
#include <linux/reboot.h>
#include <linux/regulator/coupler.h>
#include <linux/regulator/driver.h>
#include <linux/regulator/machine.h>
#include <soc/tegra/fuse.h>
#include <soc/tegra/pmc.h>
struct tegra_regulator_coupler {
struct regulator_coupler coupler;
struct regulator_dev *core_rdev;
struct regulator_dev *cpu_rdev;
struct notifier_block reboot_notifier;
int core_min_uV, cpu_min_uV;
bool sys_reboot_mode_req;
bool sys_reboot_mode;
};
static inline struct tegra_regulator_coupler *
to_tegra_coupler(struct regulator_coupler *coupler)
{
return container_of(coupler, struct tegra_regulator_coupler, coupler);
}
static int tegra30_core_limit(struct tegra_regulator_coupler *tegra,
struct regulator_dev *core_rdev)
{
int core_min_uV = 0;
int core_max_uV;
int core_cur_uV;
int err;
/*
* Tegra30 SoC has critical DVFS-capable devices that are
* permanently-active or active at a boot time, like EMC
* (DRAM controller) or Display controller for example.
*
* The voltage of a CORE SoC power domain shall not be dropped below
* a minimum level, which is determined by device's clock rate.
* This means that we can't fully allow CORE voltage scaling until
* the state of all DVFS-critical CORE devices is synced.
*/
if (tegra_pmc_core_domain_state_synced() && !tegra->sys_reboot_mode) {
pr_info_once("voltage state synced\n");
return 0;
}
if (tegra->core_min_uV > 0)
return tegra->core_min_uV;
core_cur_uV = regulator_get_voltage_rdev(core_rdev);
if (core_cur_uV < 0)
return core_cur_uV;
core_max_uV = max(core_cur_uV, 1200000);
err = regulator_check_voltage(core_rdev, &core_min_uV, &core_max_uV);
if (err)
return err;
/*
* Limit minimum CORE voltage to a value left from bootloader or,
* if it's unreasonably low value, to the most common 1.2v or to
* whatever maximum value defined via board's device-tree.
*/
tegra->core_min_uV = core_max_uV;
pr_info("core voltage initialized to %duV\n", tegra->core_min_uV);
return tegra->core_min_uV;
}
static int tegra30_core_cpu_limit(int cpu_uV)
{
if (cpu_uV < 800000)
return 950000;
if (cpu_uV < 900000)
return 1000000;
if (cpu_uV < 1000000)
return 1100000;
if (cpu_uV < 1100000)
return 1200000;
if (cpu_uV < 1250000) {
switch (tegra_sku_info.cpu_speedo_id) {
case 0 ... 1:
case 4:
case 7 ... 8:
return 1200000;
default:
return 1300000;
}
}
return -EINVAL;
}
static int tegra30_voltage_update(struct tegra_regulator_coupler *tegra,
struct regulator_dev *cpu_rdev,
struct regulator_dev *core_rdev)
{
int core_min_uV, core_max_uV = INT_MAX;
int cpu_min_uV, cpu_max_uV = INT_MAX;
int cpu_min_uV_consumers = 0;
int core_min_limited_uV;
int core_target_uV;
int cpu_target_uV;
int core_max_step;
int cpu_max_step;
int max_spread;
int core_uV;
int cpu_uV;
int err;
/*
* CPU voltage should not got lower than 300mV from the CORE.
* CPU voltage should stay below the CORE by 100mV+, depending
* by the CORE voltage. This applies to all Tegra30 SoC's.
*/
max_spread = cpu_rdev->constraints->max_spread[0];
cpu_max_step = cpu_rdev->constraints->max_uV_step;
core_max_step = core_rdev->constraints->max_uV_step;
if (!max_spread) {
pr_err_once("cpu-core max-spread is undefined in device-tree\n");
max_spread = 300000;
}
if (!cpu_max_step) {
pr_err_once("cpu max-step is undefined in device-tree\n");
cpu_max_step = 150000;
}
if (!core_max_step) {
pr_err_once("core max-step is undefined in device-tree\n");
core_max_step = 150000;
}
/*
* The CORE voltage scaling is currently not hooked up in drivers,
* hence we will limit the minimum CORE voltage to a reasonable value.
* This should be good enough for the time being.
*/
core_min_uV = tegra30_core_limit(tegra, core_rdev);
if (core_min_uV < 0)
return core_min_uV;
err = regulator_check_consumers(core_rdev, &core_min_uV, &core_max_uV,
PM_SUSPEND_ON);
if (err)
return err;
core_uV = regulator_get_voltage_rdev(core_rdev);
if (core_uV < 0)
return core_uV;
cpu_min_uV = core_min_uV - max_spread;
err = regulator_check_consumers(cpu_rdev, &cpu_min_uV, &cpu_max_uV,
PM_SUSPEND_ON);
if (err)
return err;
err = regulator_check_consumers(cpu_rdev, &cpu_min_uV_consumers,
&cpu_max_uV, PM_SUSPEND_ON);
if (err)
return err;
err = regulator_check_voltage(cpu_rdev, &cpu_min_uV, &cpu_max_uV);
if (err)
return err;
cpu_uV = regulator_get_voltage_rdev(cpu_rdev);
if (cpu_uV < 0)
return cpu_uV;
/* store boot voltage level */
if (!tegra->cpu_min_uV)
tegra->cpu_min_uV = cpu_uV;
/*
* CPU's regulator may not have any consumers, hence the voltage
* must not be changed in that case because CPU simply won't
* survive the voltage drop if it's running on a higher frequency.
*/
if (!cpu_min_uV_consumers)
cpu_min_uV = max(cpu_uV, cpu_min_uV);
/*
* Bootloader shall set up voltages correctly, but if it
* happens that there is a violation, then try to fix it
* at first.
*/
core_min_limited_uV = tegra30_core_cpu_limit(cpu_uV);
if (core_min_limited_uV < 0)
return core_min_limited_uV;
core_min_uV = max(core_min_uV, tegra30_core_cpu_limit(cpu_min_uV));
err = regulator_check_voltage(core_rdev, &core_min_uV, &core_max_uV);
if (err)
return err;
/* restore boot voltage level */
if (tegra->sys_reboot_mode)
cpu_min_uV = max(cpu_min_uV, tegra->cpu_min_uV);
if (core_min_limited_uV > core_uV) {
pr_err("core voltage constraint violated: %d %d %d\n",
core_uV, core_min_limited_uV, cpu_uV);
goto update_core;
}
while (cpu_uV != cpu_min_uV || core_uV != core_min_uV) {
if (cpu_uV < cpu_min_uV) {
cpu_target_uV = min(cpu_uV + cpu_max_step, cpu_min_uV);
} else {
cpu_target_uV = max(cpu_uV - cpu_max_step, cpu_min_uV);
cpu_target_uV = max(core_uV - max_spread, cpu_target_uV);
}
if (cpu_uV == cpu_target_uV)
goto update_core;
err = regulator_set_voltage_rdev(cpu_rdev,
cpu_target_uV,
cpu_max_uV,
PM_SUSPEND_ON);
if (err)
return err;
cpu_uV = cpu_target_uV;
update_core:
core_min_limited_uV = tegra30_core_cpu_limit(cpu_uV);
if (core_min_limited_uV < 0)
return core_min_limited_uV;
core_target_uV = max(core_min_limited_uV, core_min_uV);
if (core_uV < core_target_uV) {
core_target_uV = min(core_target_uV, core_uV + core_max_step);
core_target_uV = min(core_target_uV, cpu_uV + max_spread);
} else {
core_target_uV = max(core_target_uV, core_uV - core_max_step);
}
if (core_uV == core_target_uV)
continue;
err = regulator_set_voltage_rdev(core_rdev,
core_target_uV,
core_max_uV,
PM_SUSPEND_ON);
if (err)
return err;
core_uV = core_target_uV;
}
return 0;
}
static int tegra30_regulator_balance_voltage(struct regulator_coupler *coupler,
struct regulator_dev *rdev,
suspend_state_t state)
{
struct tegra_regulator_coupler *tegra = to_tegra_coupler(coupler);
struct regulator_dev *core_rdev = tegra->core_rdev;
struct regulator_dev *cpu_rdev = tegra->cpu_rdev;
if ((core_rdev != rdev && cpu_rdev != rdev) || state != PM_SUSPEND_ON) {
pr_err("regulators are not coupled properly\n");
return -EINVAL;
}
tegra->sys_reboot_mode = READ_ONCE(tegra->sys_reboot_mode_req);
return tegra30_voltage_update(tegra, cpu_rdev, core_rdev);
}
static int tegra30_regulator_prepare_reboot(struct tegra_regulator_coupler *tegra,
bool sys_reboot_mode)
{
int err;
if (!tegra->core_rdev || !tegra->cpu_rdev)
return 0;
WRITE_ONCE(tegra->sys_reboot_mode_req, true);
/*
* Some devices use CPU soft-reboot method and in this case we
* should ensure that voltages are sane for the reboot by restoring
* the minimum boot levels.
*/
err = regulator_sync_voltage_rdev(tegra->cpu_rdev);
if (err)
return err;
err = regulator_sync_voltage_rdev(tegra->core_rdev);
if (err)
return err;
WRITE_ONCE(tegra->sys_reboot_mode_req, sys_reboot_mode);
return 0;
}
static int tegra30_regulator_reboot(struct notifier_block *notifier,
unsigned long event, void *cmd)
{
struct tegra_regulator_coupler *tegra;
int ret;
if (event != SYS_RESTART)
return NOTIFY_DONE;
tegra = container_of(notifier, struct tegra_regulator_coupler,
reboot_notifier);
ret = tegra30_regulator_prepare_reboot(tegra, true);
return notifier_from_errno(ret);
}
static int tegra30_regulator_attach(struct regulator_coupler *coupler,
struct regulator_dev *rdev)
{
struct tegra_regulator_coupler *tegra = to_tegra_coupler(coupler);
struct device_node *np = rdev->dev.of_node;
if (of_property_read_bool(np, "nvidia,tegra-core-regulator") &&
!tegra->core_rdev) {
tegra->core_rdev = rdev;
return 0;
}
if (of_property_read_bool(np, "nvidia,tegra-cpu-regulator") &&
!tegra->cpu_rdev) {
tegra->cpu_rdev = rdev;
return 0;
}
return -EINVAL;
}
static int tegra30_regulator_detach(struct regulator_coupler *coupler,
struct regulator_dev *rdev)
{
struct tegra_regulator_coupler *tegra = to_tegra_coupler(coupler);
/*
* We don't expect regulators to be decoupled during reboot,
* this may race with the reboot handler and shouldn't ever
* happen in practice.
*/
if (WARN_ON_ONCE(system_state > SYSTEM_RUNNING))
return -EPERM;
if (tegra->core_rdev == rdev) {
tegra->core_rdev = NULL;
return 0;
}
if (tegra->cpu_rdev == rdev) {
tegra->cpu_rdev = NULL;
return 0;
}
return -EINVAL;
}
static struct tegra_regulator_coupler tegra30_coupler = {
.coupler = {
.attach_regulator = tegra30_regulator_attach,
.detach_regulator = tegra30_regulator_detach,
.balance_voltage = tegra30_regulator_balance_voltage,
},
.reboot_notifier.notifier_call = tegra30_regulator_reboot,
};
static int __init tegra_regulator_coupler_init(void)
{
int err;
if (!of_machine_is_compatible("nvidia,tegra30"))
return 0;
err = register_reboot_notifier(&tegra30_coupler.reboot_notifier);
WARN_ON(err);
return regulator_coupler_register(&tegra30_coupler.coupler);
}
arch_initcall(tegra_regulator_coupler_init);