IPv6: Add 'autoconf' and 'disable_ipv6' module parameters
Add 'autoconf' and 'disable_ipv6' parameters to the IPv6 module.
The first controls if IPv6 addresses are autoconfigured from
prefixes received in Router Advertisements. The IPv6 loopback
(::1) and link-local addresses are still configured.
The second controls if IPv6 addresses are desired at all. No
IPv6 addresses will be added to any interfaces.
Signed-off-by: Brian Haley <brian.haley@hp.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/Documentation/networking/ipv6.txt b/Documentation/networking/ipv6.txt
index 268e5c1..9fd7e21 100644
--- a/Documentation/networking/ipv6.txt
+++ b/Documentation/networking/ipv6.txt
@@ -33,3 +33,40 @@
A reboot is required to enable IPv6.
+autoconf
+
+ Specifies whether to enable IPv6 address autoconfiguration
+ on all interfaces. This might be used when one does not wish
+ for addresses to be automatically generated from prefixes
+ received in Router Advertisements.
+
+ The possible values and their effects are:
+
+ 0
+ IPv6 address autoconfiguration is disabled on all interfaces.
+
+ Only the IPv6 loopback address (::1) and link-local addresses
+ will be added to interfaces.
+
+ 1
+ IPv6 address autoconfiguration is enabled on all interfaces.
+
+ This is the default value.
+
+disable_ipv6
+
+ Specifies whether to disable IPv6 on all interfaces.
+ This might be used when no IPv6 addresses are desired.
+
+ The possible values and their effects are:
+
+ 0
+ IPv6 is enabled on all interfaces.
+
+ This is the default value.
+
+ 1
+ IPv6 is disabled on all interfaces.
+
+ No IPv6 addresses will be added to interfaces.
+
