[S390] cio: fix quiesce state
DEV_STATE_QUIESCE is used to stop all IO on a busy subchannel.
This patch fixes the following problems related to the QUIESCE
state:
* Fix a potential race condition which could occur when the
resulting state was DEV_STATE_OFFLINE.
* Add missing locking around cio_disable_subchannel,
ccw_device_cancel_halt_clear and the cdev's handler.
* Loop until we know for sure that the subchannel is disabled.
Signed-off-by: Sebastian Ott <sebott@linux.vnet.ibm.com>
Signed-off-by: Martin Schwidefsky <schwidefsky@de.ibm.com>
diff --git a/drivers/s390/cio/device_fsm.c b/drivers/s390/cio/device_fsm.c
index 7d42417..862b89e 100644
--- a/drivers/s390/cio/device_fsm.c
+++ b/drivers/s390/cio/device_fsm.c
@@ -911,10 +911,7 @@
ccw_device_quiesce_done(struct ccw_device *cdev, enum dev_event dev_event)
{
ccw_device_set_timeout(cdev, 0);
- if (dev_event == DEV_EVENT_NOTOPER)
- cdev->private->state = DEV_STATE_NOT_OPER;
- else
- cdev->private->state = DEV_STATE_OFFLINE;
+ cdev->private->state = DEV_STATE_NOT_OPER;
wake_up(&cdev->private->wait_q);
}
@@ -924,17 +921,11 @@
int ret;
ret = ccw_device_cancel_halt_clear(cdev);
- switch (ret) {
- case 0:
- cdev->private->state = DEV_STATE_OFFLINE;
- wake_up(&cdev->private->wait_q);
- break;
- case -ENODEV:
+ if (ret == -EBUSY) {
+ ccw_device_set_timeout(cdev, HZ/10);
+ } else {
cdev->private->state = DEV_STATE_NOT_OPER;
wake_up(&cdev->private->wait_q);
- break;
- default:
- ccw_device_set_timeout(cdev, HZ/10);
}
}
