drivers/block/floppy.c: add function is_ready_state
Used a couple of times, might simplify the code a bit.
Signed-off-by: Joe Perches <joe@perches.com>
Cc: Stephen Hemminger <shemminger@vyatta.com>
Cc: Jens Axboe <jens.axboe@oracle.com>
Cc: Marcin Slusarz <marcin.slusarz@gmail.com>
Cc: Bartlomiej Zolnierkiewicz <bzolnier@gmail.com>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
diff --git a/drivers/block/floppy.c b/drivers/block/floppy.c
index e080e19..1264102 100644
--- a/drivers/block/floppy.c
+++ b/drivers/block/floppy.c
@@ -782,6 +782,12 @@
return ((dor & (0x10 << unit)) && (dor & 3) == unit);
}
+static bool is_ready_state(int status)
+{
+ int state = status & (STATUS_READY | STATUS_DIR | STATUS_DMA);
+ return state == STATUS_READY;
+}
+
static int set_dor(int fdc, char mask, char data)
{
unsigned char unit;
@@ -823,8 +829,10 @@
DRS->select_date = jiffies;
}
-/* reset all driver information about the current fdc. This is needed after
- * a reset, and after a raw command. */
+/*
+ * Reset all driver information about the current fdc.
+ * This is needed after a reset, and after a raw command.
+ */
static void reset_fdc_info(int mode)
{
int drive;
@@ -1162,7 +1170,8 @@
if (status < 0)
return -1;
- if ((status & (STATUS_READY | STATUS_DIR | STATUS_DMA)) == STATUS_READY) {
+
+ if (is_ready_state(status)) {
fd_outb(byte, FD_DATA);
#ifdef FLOPPY_SANITY_CHECK
output_log[output_log_pos].data = byte;
@@ -1221,8 +1230,10 @@
if (status < 0)
return -1;
- if ((status & (STATUS_READY | STATUS_DIR | STATUS_DMA)) == STATUS_READY)
+
+ if (is_ready_state(status))
return MORE_OUTPUT;
+
return result();
}
