usb: musb: Add extvbus in musb_board_data
EXTVBUS programming is required by OMAP3EVM REV >=E to supply 500mA
power so adding a flag which can be used by musb driver to program
EXTVBUS.
Signed-off-by: Ajay Kumar Gupta <ajay.gupta@ti.com>
Signed-off-by: Felipe Balbi <felipe.balbi@nokia.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>
diff --git a/arch/arm/mach-omap2/board-omap3evm.c b/arch/arm/mach-omap2/board-omap3evm.c
index 017bb2f..7d7b5bc 100644
--- a/arch/arm/mach-omap2/board-omap3evm.c
+++ b/arch/arm/mach-omap2/board-omap3evm.c
@@ -702,6 +702,9 @@
omap_mux_init_gpio(21, OMAP_PIN_INPUT_PULLUP);
ehci_pdata.reset_gpio_port[1] = 21;
+ /* EVM REV >= E can supply 500mA with EXTVBUS programming */
+ musb_board_data.power = 500;
+ musb_board_data.extvbus = 1;
} else {
/* setup EHCI phy reset on MDC */
omap_mux_init_gpio(135, OMAP_PIN_OUTPUT);
diff --git a/arch/arm/mach-omap2/usb-musb.c b/arch/arm/mach-omap2/usb-musb.c
index 6d41fa7..96f6787 100644
--- a/arch/arm/mach-omap2/usb-musb.c
+++ b/arch/arm/mach-omap2/usb-musb.c
@@ -107,6 +107,7 @@
musb_plat.board_data = board_data;
musb_plat.power = board_data->power >> 1;
musb_plat.mode = board_data->mode;
+ musb_plat.extvbus = board_data->extvbus;
if (platform_device_register(&musb_device) < 0)
printk(KERN_ERR "Unable to register HS-USB (MUSB) device\n");
diff --git a/arch/arm/plat-omap/include/plat/usb.h b/arch/arm/plat-omap/include/plat/usb.h
index 876ca8d..60c734f 100644
--- a/arch/arm/plat-omap/include/plat/usb.h
+++ b/arch/arm/plat-omap/include/plat/usb.h
@@ -47,6 +47,7 @@
u8 interface_type;
u8 mode;
u16 power;
+ unsigned extvbus:1;
};
enum musb_interface {MUSB_INTERFACE_ULPI, MUSB_INTERFACE_UTMI};
