net: mv643xx_eth: properly start/stop phy device
When using phydev, it should be phy_start/phy_stop'ed properly. This
driver doesn't do that, so add the corresponding calls to port_start/
stop respectively.
Signed-off-by: Sebastian Hesselbarth <sebastian.hesselbarth@gmail.com>
Acked-by: Mugunthan V N <mugunthanvnm@ti.com>
Reviewed-by: Florian Fainelli <f.fainelli@gmail.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/ethernet/marvell/mv643xx_eth.c b/drivers/net/ethernet/marvell/mv643xx_eth.c
index b3d9327..a2565ce 100644
--- a/drivers/net/ethernet/marvell/mv643xx_eth.c
+++ b/drivers/net/ethernet/marvell/mv643xx_eth.c
@@ -2080,6 +2080,7 @@
mv643xx_eth_get_settings(mp->dev, &cmd);
phy_init_hw(mp->phy);
mv643xx_eth_set_settings(mp->dev, &cmd);
+ phy_start(mp->phy);
}
/*
@@ -2275,7 +2276,8 @@
del_timer_sync(&mp->rx_oom);
netif_carrier_off(dev);
-
+ if (mp->phy)
+ phy_stop(mp->phy);
free_irq(dev->irq, dev);
port_reset(mp);
