blob: d97b0361535b0986f79732cdacaabf0ba581b681 [file] [log] [blame]
WDT Watchdog Timer Interfaces For The Linux Operating System
Last Reviewed: 10/05/2007
Alan Cox <>
- ICS WDT501-P
- ICS WDT501-P (no fan tachometer)
- ICS WDT500-P
All the interfaces provide /dev/watchdog, which when open must be written
to within a timeout or the machine will reboot. Each write delays the reboot
time another timeout. In the case of the software watchdog the ability to
reboot will depend on the state of the machines and interrupts. The hardware
boards physically pull the machine down off their own onboard timers and
will reboot from almost anything.
A second temperature monitoring interface is available on the WDT501P cards.
This provides /dev/temperature. This is the machine internal temperature in
degrees Fahrenheit. Each read returns a single byte giving the temperature.
The third interface logs kernel messages on additional alert events.
The ICS ISA-bus wdt card cannot be safely probed for. Instead you need to
pass IO address and IRQ boot parameters. E.g.:: wdt.irq=11
Other "wdt" driver parameters are:
=========== ======================================================
heartbeat Watchdog heartbeat in seconds (default 60)
nowayout Watchdog cannot be stopped once started (kernel
build parameter)
tachometer WDT501-P Fan Tachometer support (0=disable, default=0)
type WDT501-P Card type (500 or 501, default=500)
=========== ======================================================
================ ======= =======
================ ======= =======
Reboot Timer X X
External Reboot X X
I/O Port Monitor o o
Temperature X o
Fan Speed X o
Power Under X o
Power Over X o
Overheat X o
================ ======= =======
The external event interfaces on the WDT boards are not currently supported.
Minor numbers are however allocated for it.
Example Watchdog Driver:
see samples/watchdog/watchdog-simple.c