serial: 8250_omap: Remove auto-IXON flow control
OMAP h/w-assisted IXON flow control is borked. The transmitter becomes
stuck if XON is never received; clearing the fifos or resetting the
rx flow control bits has no effect.
Remove auto-IXANY as well, since without auto-IXON, it has no purpose.
Signed-off-by: Peter Hurley <peter@hurleysoftware.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
diff --git a/drivers/tty/serial/8250/8250_omap.c b/drivers/tty/serial/8250/8250_omap.c
index d9a3719..0340ee6 100644
--- a/drivers/tty/serial/8250/8250_omap.c
+++ b/drivers/tty/serial/8250/8250_omap.c
@@ -447,12 +447,9 @@
priv->efr |= UART_EFR_CTS;
} else if (up->port.flags & UPF_SOFT_FLOW) {
/*
- * IXON Flag:
- * Enable XON/XOFF flow control on input.
- * Receiver compares XON1, XOFF1.
+ * OMAP rx s/w flow control is borked; the transmitter remains
+ * stuck off even if rx flow control is subsequently disabled
*/
- if (termios->c_iflag & IXON)
- priv->efr |= OMAP_UART_SW_RX;
/*
* IXOFF Flag:
@@ -463,15 +460,6 @@
up->port.status |= UPSTAT_AUTOXOFF;
priv->efr |= OMAP_UART_SW_TX;
}
-
- /*
- * IXANY Flag:
- * Enable any character to restart output.
- * Operation resumes after receiving any
- * character after recognition of the XOFF character
- */
- if (termios->c_iflag & IXANY)
- up->mcr |= UART_MCR_XONANY;
}
omap8250_restore_regs(up);
