serial: xilinx: Use platform_get_irq to get irq description structure
For systems with CONFIG_SERIAL_OF_PLATFORM=y and device_type =
"serial"; property in DT of_serial.c driver maps and unmaps IRQ (because
driver probe fails). Then a driver is called but irq mapping is not
created that's why driver is failing again in again on request_irq().
Based on this use platform_get_irq() instead of platform_get_resource()
which is doing irq_desc allocation and driver itself can request IRQ.
Fix both xilinx serial drivers in the tree.
Signed-off-by: Michal Simek <michal.simek@xilinx.com>
CC: <stable@vger.kernel.org>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
diff --git a/drivers/tty/serial/xilinx_uartps.c b/drivers/tty/serial/xilinx_uartps.c
index f218ec6..3ddbac7 100644
--- a/drivers/tty/serial/xilinx_uartps.c
+++ b/drivers/tty/serial/xilinx_uartps.c
@@ -1331,9 +1331,9 @@
*/
static int cdns_uart_probe(struct platform_device *pdev)
{
- int rc, id;
+ int rc, id, irq;
struct uart_port *port;
- struct resource *res, *res2;
+ struct resource *res;
struct cdns_uart *cdns_uart_data;
cdns_uart_data = devm_kzalloc(&pdev->dev, sizeof(*cdns_uart_data),
@@ -1380,9 +1380,9 @@
goto err_out_clk_disable;
}
- res2 = platform_get_resource(pdev, IORESOURCE_IRQ, 0);
- if (!res2) {
- rc = -ENODEV;
+ irq = platform_get_irq(pdev, 0);
+ if (irq <= 0) {
+ rc = -ENXIO;
goto err_out_clk_disable;
}
@@ -1411,7 +1411,7 @@
* and triggers invocation of the config_port() entry point.
*/
port->mapbase = res->start;
- port->irq = res2->start;
+ port->irq = irq;
port->dev = &pdev->dev;
port->uartclk = clk_get_rate(cdns_uart_data->uartclk);
port->private_data = cdns_uart_data;
