tree d955aff3e052e310b0c585056341072ce427ace6
parent bcd623d8e9fa5f82bbd8cd464dc418d24139157b
author Xin Long <lucien.xin@gmail.com> 1603955106 +0800
committer Jakub Kicinski <kuba@kernel.org> 1604096670 -0700

sctp: support for sending packet over udp4 sock

This patch does what the rfc6951#section-5.3 says for ipv4:

  "Within the UDP header, the source port MUST be the local UDP
   encapsulation port number of the SCTP stack, and the destination port
   MUST be the remote UDP encapsulation port number maintained for the
   association and the destination address to which the packet is sent
   (see Section 5.1).

   Because the SCTP packet is the UDP payload, the length of the UDP
   packet MUST be the length of the SCTP packet plus the size of the UDP
   header.

   The SCTP checksum MUST be computed for IPv4 and IPv6, and the UDP
   checksum SHOULD be computed for IPv4 and IPv6."

Some places need to be adjusted in sctp_packet_transmit():

  1. For non-gso packets, when transport's encap_port is set, sctp
     checksum has to be done in sctp_packet_pack(), as the outer
     udp will use ip_summed = CHECKSUM_PARTIAL to do the offload
     setting for checksum.

  2. Delay calling dst_clone() and skb_dst_set() for non-udp packets
     until sctp_v4_xmit(), as for udp packets, skb_dst_set() is not
     needed before calling udp_tunnel_xmit_skb().

then in sctp_v4_xmit():

  1. Go to udp_tunnel_xmit_skb() only when transport->encap_port and
     net->sctp.udp_port both are set, as these are one for dst port
     and another for src port.

  2. For gso packet, SKB_GSO_UDP_TUNNEL_CSUM is set for gso_type, and
     with this udp checksum can be done in __skb_udp_tunnel_segment()
     for each segments after the sctp gso.

  3. inner_mac_header and inner_transport_header are set, as these
     will be needed in __skb_udp_tunnel_segment() to find the right
     headers.

  4. df and ttl are calculated, as these are the required params by
     udp_tunnel_xmit_skb().

  5. nocheck param has to be false, as "the UDP checksum SHOULD be
     computed for IPv4 and IPv6", says in rfc6951#section-5.3.

v1->v2:
  - Use sp->udp_port instead in sctp_v4_xmit(), which is more safe.

Signed-off-by: Xin Long <lucien.xin@gmail.com>
Acked-by: Marcelo Ricardo Leitner <marcelo.leitner@gmail.com>
Signed-off-by: Jakub Kicinski <kuba@kernel.org>