of: Always use 'struct device.of_node' to get device node pointer.
The following structure elements duplicate the information in
'struct device.of_node' and so are being eliminated. This patch
makes all readers of these elements use device.of_node instead.
(struct of_device *)->node
(struct dev_archdata *)->prom_node (sparc)
(struct dev_archdata *)->of_node (powerpc & microblaze)
Signed-off-by: Grant Likely <grant.likely@secretlab.ca>
diff --git a/drivers/atm/fore200e.c b/drivers/atm/fore200e.c
index f7d6eba..593a03a 100644
--- a/drivers/atm/fore200e.c
+++ b/drivers/atm/fore200e.c
@@ -789,7 +789,7 @@
fore200e->bus->write(0x02, fore200e->regs.sba.isr); /* XXX hardwired interrupt level */
/* get the supported DVMA burst sizes */
- bursts = of_getintprop_default(op->node->parent, "burst-sizes", 0x00);
+ bursts = of_getintprop_default(op->dev.of_node->parent, "burst-sizes", 0x00);
if (sbus_can_dma_64bit())
sbus_set_sbus64(&op->dev, bursts);
@@ -820,18 +820,20 @@
const u8 *prop;
int len;
- prop = of_get_property(op->node, "madaddrlo2", &len);
+ prop = of_get_property(op->dev.of_node, "madaddrlo2", &len);
if (!prop)
return -ENODEV;
memcpy(&prom->mac_addr[4], prop, 4);
- prop = of_get_property(op->node, "madaddrhi4", &len);
+ prop = of_get_property(op->dev.of_node, "madaddrhi4", &len);
if (!prop)
return -ENODEV;
memcpy(&prom->mac_addr[2], prop, 4);
- prom->serial_number = of_getintprop_default(op->node, "serialnumber", 0);
- prom->hw_revision = of_getintprop_default(op->node, "promversion", 0);
+ prom->serial_number = of_getintprop_default(op->dev.of_node,
+ "serialnumber", 0);
+ prom->hw_revision = of_getintprop_default(op->dev.of_node,
+ "promversion", 0);
return 0;
}
@@ -841,10 +843,10 @@
struct of_device *op = fore200e->bus_dev;
const struct linux_prom_registers *regs;
- regs = of_get_property(op->node, "reg", NULL);
+ regs = of_get_property(op->dev.of_node, "reg", NULL);
return sprintf(page, " SBUS slot/device:\t\t%d/'%s'\n",
- (regs ? regs->which_io : 0), op->node->name);
+ (regs ? regs->which_io : 0), op->dev.of_node->name);
}
#endif /* CONFIG_SBUS */
