ARM: 6094/1: Extend cache-l2x0 to support the 16-way PL310
The L310 cache controller's interface is almost identical
to the L210. One major difference is that the PL310 can
have up to 16 ways.
This change uses the cache's part ID and the Associativity
bits in the AUX_CTRL register to determine the number of ways.
Also, this version prints out the CACHE_ID and AUX_CTRL registers.
Acked-by: Will Deacon <will.deacon@arm.com>
Acked-by: Acked-by: Catalin Marinas <catalin.marinas@arm.com>
Signed-off-by: Jason S. McMullan <jason.mcmullan@netronome.com>
Signed-off-by: Russell King <rmk+kernel@arm.linux.org.uk>
diff --git a/arch/arm/mm/cache-l2x0.c b/arch/arm/mm/cache-l2x0.c
index 0733463..78f0fc8 100644
--- a/arch/arm/mm/cache-l2x0.c
+++ b/arch/arm/mm/cache-l2x0.c
@@ -27,6 +27,7 @@
static void __iomem *l2x0_base;
static DEFINE_SPINLOCK(l2x0_lock);
+static uint32_t l2x0_way_mask; /* Bitmask of active ways */
static inline void cache_wait(void __iomem *reg, unsigned long mask)
{
@@ -99,8 +100,8 @@
/* invalidate all ways */
spin_lock_irqsave(&l2x0_lock, flags);
- writel(0xff, l2x0_base + L2X0_INV_WAY);
- cache_wait(l2x0_base + L2X0_INV_WAY, 0xff);
+ writel(l2x0_way_mask, l2x0_base + L2X0_INV_WAY);
+ cache_wait(l2x0_base + L2X0_INV_WAY, l2x0_way_mask);
cache_sync();
spin_unlock_irqrestore(&l2x0_lock, flags);
}
@@ -199,9 +200,37 @@
void __init l2x0_init(void __iomem *base, __u32 aux_val, __u32 aux_mask)
{
__u32 aux;
+ __u32 cache_id;
+ int ways;
+ const char *type;
l2x0_base = base;
+ cache_id = readl(l2x0_base + L2X0_CACHE_ID);
+ aux = readl(l2x0_base + L2X0_AUX_CTRL);
+
+ /* Determine the number of ways */
+ switch (cache_id & L2X0_CACHE_ID_PART_MASK) {
+ case L2X0_CACHE_ID_PART_L310:
+ if (aux & (1 << 16))
+ ways = 16;
+ else
+ ways = 8;
+ type = "L310";
+ break;
+ case L2X0_CACHE_ID_PART_L210:
+ ways = (aux >> 13) & 0xf;
+ type = "L210";
+ break;
+ default:
+ /* Assume unknown chips have 8 ways */
+ ways = 8;
+ type = "L2x0 series";
+ break;
+ }
+
+ l2x0_way_mask = (1 << ways) - 1;
+
/*
* Check if l2x0 controller is already enabled.
* If you are booting from non-secure mode
@@ -210,8 +239,6 @@
if (!(readl(l2x0_base + L2X0_CTRL) & 1)) {
/* l2x0 controller is disabled */
-
- aux = readl(l2x0_base + L2X0_AUX_CTRL);
aux &= aux_mask;
aux |= aux_val;
writel(aux, l2x0_base + L2X0_AUX_CTRL);
@@ -226,5 +253,7 @@
outer_cache.clean_range = l2x0_clean_range;
outer_cache.flush_range = l2x0_flush_range;
- printk(KERN_INFO "L2X0 cache controller enabled\n");
+ printk(KERN_INFO "%s cache controller enabled\n", type);
+ printk(KERN_INFO "l2x0: %d ways, CACHE_ID 0x%08x, AUX_CTRL 0x%08x\n",
+ ways, cache_id, aux);
}
