sh: boot kernel with SR.BL set
Update the SH kernel to keep SR.BL set until the VBR
register has been initialized. Useful to allow boot
of the kernel even though exceptions are pending.
Without this patch there is a window of time when
exceptions such as NMI are enabled but no exception
handlers are installed.
This patch modifies both the zImage loader and the
actual kernel to boot with BL=1, but the zImage
loader is modfied in such a way that the init_sr
value is unchanged to not break the zImage loader
provided by kexec.
Tested on sh7724 Ecovec and on the SH4AL-DSP core
included in sh7372.
Signed-off-by: Magnus Damm <damm@opensource.se>
Signed-off-by: Paul Mundt <lethal@linux-sh.org>
diff --git a/arch/sh/boot/compressed/head_32.S b/arch/sh/boot/compressed/head_32.S
index 200c1d4..3e15032 100644
--- a/arch/sh/boot/compressed/head_32.S
+++ b/arch/sh/boot/compressed/head_32.S
@@ -91,7 +91,9 @@
end_addr:
.long _end
init_sr:
- .long 0x400000F0 /* Privileged mode, Bank=0, Block=0, IMASK=0xF */
+ .long 0x500000F0 /* Privileged mode, Bank=0, Block=1, IMASK=0xF */
+kexec_magic:
+ .long 0x400000F0 /* magic used by kexec to parse zImage format */
init_stack_addr:
.long stack_start
decompress_kernel_addr:
diff --git a/arch/sh/kernel/head_32.S b/arch/sh/kernel/head_32.S
index 6e35f01..7db2489 100644
--- a/arch/sh/kernel/head_32.S
+++ b/arch/sh/kernel/head_32.S
@@ -330,7 +330,7 @@
#if defined(CONFIG_CPU_SH2)
1: .long 0x000000F0 ! IMASK=0xF
#else
-1: .long 0x400080F0 ! MD=1, RB=0, BL=0, FD=1, IMASK=0xF
+1: .long 0x500080F0 ! MD=1, RB=0, BL=1, FD=1, IMASK=0xF
#endif
ENTRY(stack_start)
2: .long init_thread_union+THREAD_SIZE
diff --git a/arch/sh/kernel/traps_32.c b/arch/sh/kernel/traps_32.c
index c3d86fa..f561352 100644
--- a/arch/sh/kernel/traps_32.c
+++ b/arch/sh/kernel/traps_32.c
@@ -802,6 +802,9 @@
: /* no output */
: "r" (&vbr_base)
: "memory");
+
+ /* disable exception blocking now when the vbr has been setup */
+ clear_bl_bit();
}
void *set_exception_table_vec(unsigned int vec, void *handler)
