mtd: flash drivers set ecc strength
Flash device drivers initialize 'ecc_strength' in struct mtd_info, which is the
maximum number of bit errors that can be corrected in one writesize region.
Drivers using the nand interface intitialize 'strength' in struct nand_ecc_ctrl,
which is the maximum number of bit errors that can be corrected in one ecc step.
Nand infrastructure code translates this to 'ecc_strength'.
Also for nand drivers, the nand infrastructure code sets ecc.strength for ecc
modes NAND_ECC_SOFT, NAND_ECC_SOFT_BCH, and NAND_ECC_NONE. It is set in the
driver for all other modes.
Signed-off-by: Mike Dunn <mikedunn@newsguy.com>
Signed-off-by: Artem Bityutskiy <artem.bityutskiy@linux.intel.com>
Signed-off-by: David Woodhouse <David.Woodhouse@intel.com>
diff --git a/drivers/mtd/nand/denali.c b/drivers/mtd/nand/denali.c
index 3984d48..a9e57d6 100644
--- a/drivers/mtd/nand/denali.c
+++ b/drivers/mtd/nand/denali.c
@@ -1590,6 +1590,7 @@
ECC_15BITS * (denali->mtd.writesize /
ECC_SECTOR_SIZE)))) {
/* if MLC OOB size is large enough, use 15bit ECC*/
+ denali->nand.ecc.strength = 15;
denali->nand.ecc.layout = &nand_15bit_oob;
denali->nand.ecc.bytes = ECC_15BITS;
iowrite32(15, denali->flash_reg + ECC_CORRECTION);
@@ -1600,12 +1601,14 @@
" contain 8bit ECC correction codes");
goto failed_req_irq;
} else {
+ denali->nand.ecc.strength = 8;
denali->nand.ecc.layout = &nand_8bit_oob;
denali->nand.ecc.bytes = ECC_8BITS;
iowrite32(8, denali->flash_reg + ECC_CORRECTION);
}
denali->nand.ecc.bytes *= denali->devnum;
+ denali->nand.ecc.strength *= denali->devnum;
denali->nand.ecc.layout->eccbytes *=
denali->mtd.writesize / ECC_SECTOR_SIZE;
denali->nand.ecc.layout->oobfree[0].offset =
