net/ethernet: ks8851_mll fix irq handling
There a two different irq variables ks->irq and netdev->irq.
Only ks->irq is set on probe, so disabling irq in ks_start_xmit fails.
This patches remove ks->irq from private data and use only netdev->irq.
Tested on a kernel 3.0 based OMAP4430 SMP Board
Signed-off-by: Jan Weitzel <j.weitzel@phytec.de>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/ethernet/micrel/ks8851_mll.c b/drivers/net/ethernet/micrel/ks8851_mll.c
index e58e78e..231176f 100644
--- a/drivers/net/ethernet/micrel/ks8851_mll.c
+++ b/drivers/net/ethernet/micrel/ks8851_mll.c
@@ -394,7 +394,6 @@
* @msg_enable : The message flags controlling driver output (see ethtool).
* @frame_cnt : number of frames received.
* @bus_width : i/o bus width.
- * @irq : irq number assigned to this device.
* @rc_rxqcr : Cached copy of KS_RXQCR.
* @rc_txcr : Cached copy of KS_TXCR.
* @rc_ier : Cached copy of KS_IER.
@@ -441,7 +440,6 @@
u32 msg_enable;
u32 frame_cnt;
int bus_width;
- int irq;
u16 rc_rxqcr;
u16 rc_txcr;
@@ -907,10 +905,10 @@
netif_dbg(ks, ifup, ks->netdev, "%s - entry\n", __func__);
/* reset the HW */
- err = request_irq(ks->irq, ks_irq, KS_INT_FLAGS, DRV_NAME, netdev);
+ err = request_irq(netdev->irq, ks_irq, KS_INT_FLAGS, DRV_NAME, netdev);
if (err) {
- pr_err("Failed to request IRQ: %d: %d\n", ks->irq, err);
+ pr_err("Failed to request IRQ: %d: %d\n", netdev->irq, err);
return err;
}
@@ -955,7 +953,7 @@
/* set powermode to soft power down to save power */
ks_set_powermode(ks, PMECR_PM_SOFTDOWN);
- free_irq(ks->irq, netdev);
+ free_irq(netdev->irq, netdev);
mutex_unlock(&ks->lock);
return 0;
}
@@ -1545,10 +1543,10 @@
if (!ks->hw_addr_cmd)
goto err_ioremap1;
- ks->irq = platform_get_irq(pdev, 0);
+ netdev->irq = platform_get_irq(pdev, 0);
- if (ks->irq < 0) {
- err = ks->irq;
+ if (netdev->irq < 0) {
+ err = netdev->irq;
goto err_get_irq;
}
