drm/i915: hw state readout support for pixel_multiplier
Incomplete since ilk+ support needs proper pch dpll tracking first.
SDVO get_config parts based on a patch from Jesse Barnes, but fixed up
to actually work.
v2: Make sure that we call encoder->get_config _after_ we
get_pipe_config to be consistent in both setup_hw_state and the
modeset state checker. Otherwise the clever trick with handling the
pixel mutliplier on i915G/GM where the encoder overrides the default
value of 1 from the crtc get_pipe_config function doesn't work.
Spotted by Imre Deak.
v3: Actually cross-check the pixel mutliplier (but not on pch split
platforms for now). Now actually also tested on a i915G with a sdvo
encoder plugged in.
Cc: Imre Deak <imre.deak@intel.com>
Cc: Jesse Barnes <jbarnes@virtuousgeek.org>
Reviewed-by: Imre Deak <imre.deak@intel.com>
Signed-off-by: Daniel Vetter <daniel.vetter@ffwll.ch>
diff --git a/drivers/gpu/drm/i915/intel_display.c b/drivers/gpu/drm/i915/intel_display.c
index 0e1f828..421b7e2 100644
--- a/drivers/gpu/drm/i915/intel_display.c
+++ b/drivers/gpu/drm/i915/intel_display.c
@@ -5001,6 +5001,23 @@
i9xx_get_pfit_config(crtc, pipe_config);
+ if (INTEL_INFO(dev)->gen >= 4) {
+ tmp = I915_READ(DPLL_MD(crtc->pipe));
+ pipe_config->pixel_multiplier =
+ ((tmp & DPLL_MD_UDI_MULTIPLIER_MASK)
+ >> DPLL_MD_UDI_MULTIPLIER_SHIFT) + 1;
+ } else if (IS_I945G(dev) || IS_I945GM(dev) || IS_G33(dev)) {
+ tmp = I915_READ(DPLL(crtc->pipe));
+ pipe_config->pixel_multiplier =
+ ((tmp & SDVO_MULTIPLIER_MASK)
+ >> SDVO_MULTIPLIER_SHIFT_HIRES) + 1;
+ } else {
+ /* Note that on i915G/GM the pixel multiplier is in the sdvo
+ * port and will be fixed up in the encoder->get_config
+ * function. */
+ pipe_config->pixel_multiplier = 1;
+ }
+
return true;
}
@@ -5864,6 +5881,12 @@
FDI_DP_PORT_WIDTH_SHIFT) + 1;
ironlake_get_fdi_m_n_config(crtc, pipe_config);
+
+ /* XXX: Can't properly read out the pch dpll pixel multiplier
+ * since we don't have state tracking for pch clocks yet. */
+ pipe_config->pixel_multiplier = 1;
+ } else {
+ pipe_config->pixel_multiplier = 1;
}
intel_get_pipe_timings(crtc, pipe_config);
@@ -5998,6 +6021,8 @@
pipe_config->ips_enabled = hsw_crtc_supports_ips(crtc) &&
(I915_READ(IPS_CTL) & IPS_ENABLE);
+ pipe_config->pixel_multiplier = 1;
+
return true;
}
@@ -8090,6 +8115,9 @@
PIPE_CONF_CHECK_I(adjusted_mode.crtc_vsync_start);
PIPE_CONF_CHECK_I(adjusted_mode.crtc_vsync_end);
+ if (!HAS_PCH_SPLIT(dev))
+ PIPE_CONF_CHECK_I(pixel_multiplier);
+
PIPE_CONF_CHECK_FLAGS(adjusted_mode.flags,
DRM_MODE_FLAG_INTERLACE);
@@ -8211,9 +8239,8 @@
enabled = true;
if (encoder->connectors_active)
active = true;
- if (encoder->get_config)
- encoder->get_config(encoder, &pipe_config);
}
+
WARN(active != crtc->active,
"crtc's computed active state doesn't match tracked active state "
"(expected %i, found %i)\n", active, crtc->active);
@@ -8223,6 +8250,14 @@
active = dev_priv->display.get_pipe_config(crtc,
&pipe_config);
+ list_for_each_entry(encoder, &dev->mode_config.encoder_list,
+ base.head) {
+ if (encoder->base.crtc != &crtc->base)
+ continue;
+ if (encoder->get_config)
+ encoder->get_config(encoder, &pipe_config);
+ }
+
WARN(crtc->active != active,
"crtc active state doesn't match with hw state "
"(expected %i, found %i)\n", crtc->active, active);
