net: phy: resume phydev when going to RESUMING
With commit be9dad1f9f26604fb ("net: phy: suspend phydev when going
to HALTED"), an unused PHY device will be put in a low-power mode
using BMCR_PDOWN. Some Ethernet drivers might be calling phy_start()
and phy_stop() from ndo_open and ndo_close() respectively, while
calling phy_connect() and phy_disconnect() from probe and remove.
In such a case, the PHY will be powered down during the phy_stop()
call, but will fail to be powered up in phy_start().
This patch fixes this scenario.
Signed-off-by: Jiancheng Xue <xuejiancheng@huawei.com>
Signed-off-by: Zhangfei Gao <zhangfei.gao@linaro.org>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/phy/phy.c b/drivers/net/phy/phy.c
index a972056..3bc079a 100644
--- a/drivers/net/phy/phy.c
+++ b/drivers/net/phy/phy.c
@@ -715,7 +715,7 @@
struct delayed_work *dwork = to_delayed_work(work);
struct phy_device *phydev =
container_of(dwork, struct phy_device, state_queue);
- int needs_aneg = 0, do_suspend = 0;
+ bool needs_aneg = false, do_suspend = false, do_resume = false;
int err = 0;
mutex_lock(&phydev->lock);
@@ -727,7 +727,7 @@
case PHY_PENDING:
break;
case PHY_UP:
- needs_aneg = 1;
+ needs_aneg = true;
phydev->link_timeout = PHY_AN_TIMEOUT;
@@ -757,7 +757,7 @@
phydev->adjust_link(phydev->attached_dev);
} else if (0 == phydev->link_timeout--)
- needs_aneg = 1;
+ needs_aneg = true;
break;
case PHY_NOLINK:
err = phy_read_status(phydev);
@@ -791,7 +791,7 @@
netif_carrier_on(phydev->attached_dev);
} else {
if (0 == phydev->link_timeout--)
- needs_aneg = 1;
+ needs_aneg = true;
}
phydev->adjust_link(phydev->attached_dev);
@@ -827,7 +827,7 @@
phydev->link = 0;
netif_carrier_off(phydev->attached_dev);
phydev->adjust_link(phydev->attached_dev);
- do_suspend = 1;
+ do_suspend = true;
}
break;
case PHY_RESUMING:
@@ -876,6 +876,7 @@
}
phydev->adjust_link(phydev->attached_dev);
}
+ do_resume = true;
break;
}
@@ -883,9 +884,10 @@
if (needs_aneg)
err = phy_start_aneg(phydev);
-
- if (do_suspend)
+ else if (do_suspend)
phy_suspend(phydev);
+ else if (do_resume)
+ phy_resume(phydev);
if (err < 0)
phy_error(phydev);
