scsi: pm80xx: Use phy-specific SAS address when sending PHY_START command
Some cards have more than one SAS address. Using an incorrect address
causes communication issues with some devices like expanders.
Closes: https://lore.kernel.org/linux-kernel/A57AEA84-5CA0-403E-8053-106033C73C70@fb.com/
Signed-off-by: Michal Grzedzicki <mge@meta.com>
Link: https://lore.kernel.org/r/20230913155611.3183612-1-mge@meta.com
Acked-by: Jack Wang <jinpu.wang@ionos.com>
Signed-off-by: Martin K. Petersen <martin.petersen@oracle.com>
diff --git a/drivers/scsi/pm8001/pm8001_hwi.c b/drivers/scsi/pm8001/pm8001_hwi.c
index 33053db..90069c7 100644
--- a/drivers/scsi/pm8001/pm8001_hwi.c
+++ b/drivers/scsi/pm8001/pm8001_hwi.c
@@ -4180,7 +4180,7 @@ pm8001_chip_phy_start_req(struct pm8001_hba_info *pm8001_ha, u8 phy_id)
payload.sas_identify.dev_type = SAS_END_DEVICE;
payload.sas_identify.initiator_bits = SAS_PROTOCOL_ALL;
memcpy(payload.sas_identify.sas_addr,
- pm8001_ha->sas_addr, SAS_ADDR_SIZE);
+ &pm8001_ha->phy[phy_id].dev_sas_addr, SAS_ADDR_SIZE);
payload.sas_identify.phy_id = phy_id;
return pm8001_mpi_build_cmd(pm8001_ha, 0, opcode, &payload,
