blob: f86667cbcca8993cb9e0c3abda2ab291e3c06ac3 [file] [log] [blame]
# SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
%YAML 1.2
---
$id: http://devicetree.org/schemas/net/smsc,lan9115.yaml#
$schema: http://devicetree.org/meta-schemas/core.yaml#
title: Smart Mixed-Signal Connectivity (SMSC) LAN911x/912x Controller
maintainers:
- Shawn Guo <shawnguo@kernel.org>
allOf:
- $ref: ethernet-controller.yaml#
properties:
compatible:
oneOf:
- const: smsc,lan9115
- items:
- enum:
- smsc,lan89218
- smsc,lan9117
- smsc,lan9118
- smsc,lan9220
- smsc,lan9221
- const: smsc,lan9115
reg:
maxItems: 1
reg-shift: true
reg-io-width:
enum: [ 2, 4 ]
default: 2
interrupts:
minItems: 1
items:
- description:
LAN interrupt line
- description:
Optional PME (power management event) interrupt that is able to wake
up the host system with a 50ms pulse on network activity
clocks:
maxItems: 1
phy-mode: true
smsc,irq-active-high:
type: boolean
description: Indicates the IRQ polarity is active-high
smsc,irq-push-pull:
type: boolean
description: Indicates the IRQ type is push-pull
smsc,force-internal-phy:
type: boolean
description: Forces SMSC LAN controller to use internal PHY
smsc,force-external-phy:
type: boolean
description: Forces SMSC LAN controller to use external PHY
smsc,save-mac-address:
type: boolean
description:
Indicates that MAC address needs to be saved before resetting the
controller
reset-gpios:
maxItems: 1
description:
A GPIO line connected to the RESET (active low) signal of the device.
On many systems this is wired high so the device goes out of reset at
power-on, but if it is under program control, this optional GPIO can
wake up in response to it.
vdd33a-supply:
description: 3.3V analog power supply
vddvario-supply:
description: IO logic power supply
required:
- compatible
- reg
- interrupts
# There are lots of bus-specific properties ("qcom,*", "samsung,*", "fsl,*",
# "gpmc,*", ...) to be found, that actually depend on the compatible value of
# the parent node.
additionalProperties: true
examples:
- |
#include <dt-bindings/gpio/gpio.h>
ethernet@f4000000 {
compatible = "smsc,lan9220", "smsc,lan9115";
reg = <0xf4000000 0x2000000>;
phy-mode = "mii";
interrupt-parent = <&gpio1>;
interrupts = <31>, <32>;
reset-gpios = <&gpio1 30 GPIO_ACTIVE_LOW>;
reg-io-width = <4>;
smsc,irq-push-pull;
};