| # SPDX-License-Identifier: GPL-2.0-only |
| config QCOM_TSENS |
| tristate "Qualcomm TSENS Temperature Alarm" |
| depends on QCOM_QFPROM |
| depends on ARCH_QCOM || COMPILE_TEST |
| help |
| This enables the thermal sysfs driver for the TSENS device. It shows |
| up in Sysfs as a thermal zone with multiple trip points. Disabling the |
| thermal zone device via the mode file results in disabling the sensor. |
| Also able to set threshold temperature for both hot and cold and update |
| when a threshold is reached. |
| |
| config QCOM_SPMI_ADC_TM5 |
| tristate "Qualcomm SPMI PMIC Thermal Monitor ADC5" |
| depends on OF && SPMI && IIO |
| select REGMAP_SPMI |
| select QCOM_VADC_COMMON |
| help |
| This enables the thermal driver for the ADC thermal monitoring |
| device. It shows up as a thermal zone with multiple trip points. |
| Thermal client sets threshold temperature for both warm and cool and |
| gets updated when a threshold is reached. |
| |
| config QCOM_SPMI_TEMP_ALARM |
| tristate "Qualcomm SPMI PMIC Temperature Alarm" |
| depends on OF && SPMI && IIO |
| select REGMAP_SPMI |
| help |
| This enables a thermal sysfs driver for Qualcomm plug-and-play (QPNP) |
| PMIC devices. It shows up in sysfs as a thermal sensor with multiple |
| trip points. The temperature reported by the thermal sensor reflects the |
| real time die temperature if an ADC is present or an estimate of the |
| temperature based upon the over temperature stage value. |
| |
| config QCOM_LMH |
| tristate "Qualcomm Limits Management Hardware" |
| depends on ARCH_QCOM && QCOM_SCM |
| help |
| This enables initialization of Qualcomm limits management |
| hardware(LMh). LMh allows for hardware-enforced mitigation for cpus based on |
| input from temperature and current sensors. On many newer Qualcomm SoCs |
| LMh is configured in the firmware and this feature need not be enabled. |
| However, on certain SoCs like sdm845 LMh has to be configured from kernel. |
