net: phy: display human readable PHY speed settings
Use a convenience function: phy_speed_to_str() which will display human
readable speeds.
Suggested-by: Joe Perches <joe@perches.com>
Signed-off-by: Florian Fainelli <f.fainelli@gmail.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/phy/phy.c b/drivers/net/phy/phy.c
index 8ae2260..36fc6e1 100644
--- a/drivers/net/phy/phy.c
+++ b/drivers/net/phy/phy.c
@@ -38,6 +38,26 @@
#include <asm/irq.h>
+static const char *phy_speed_to_str(int speed)
+{
+ switch (speed) {
+ case SPEED_10:
+ return "10Mbps";
+ case SPEED_100:
+ return "100Mbps";
+ case SPEED_1000:
+ return "1Gbps";
+ case SPEED_2500:
+ return "2.5Gbps";
+ case SPEED_10000:
+ return "10Gbps";
+ case SPEED_UNKNOWN:
+ return "Unknown";
+ default:
+ return "Unsupported (update phy.c)";
+ }
+}
+
/**
* phy_print_status - Convenience function to print out the current phy status
* @phydev: the phy_device struct
@@ -46,8 +66,8 @@
{
if (phydev->link) {
netdev_info(phydev->attached_dev,
- "Link is Up - %d/%s - flow control %s\n",
- phydev->speed,
+ "Link is Up - %s/%s - flow control %s\n",
+ phy_speed_to_str(phydev->speed),
DUPLEX_FULL == phydev->duplex ? "Full" : "Half",
phydev->pause ? "rx/tx" : "off");
} else {
