ALSA: x86: Rearrange defines
We have two header files and everything is mixed up chaotically.
Move the chip-specific definitions like the hardware registers to
intel_hdmi_lpe_audio.h, and the rest, the implementation specific
stuff into intel_hdmi_audio.h.
In addition, put some more comments to the register fields, and fix
the incorrect name prefix for AUD_HDMI_STATUS bits, too.
The whole changes are merely a code shuffling, and there is no
functional change.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
diff --git a/sound/x86/intel_hdmi_lpe_audio.h b/sound/x86/intel_hdmi_lpe_audio.h
index 48cab1b..97bbca1 100644
--- a/sound/x86/intel_hdmi_lpe_audio.h
+++ b/sound/x86/intel_hdmi_lpe_audio.h
@@ -23,7 +23,6 @@
#ifndef __INTEL_HDMI_LPE_AUDIO_H
#define __INTEL_HDMI_LPE_AUDIO_H
-#define HAD_MAX_DEVICES 1
#define HAD_MIN_CHANNEL 2
#define HAD_MAX_CHANNEL 8
#define HAD_NUM_OF_RING_BUFS 4
@@ -55,9 +54,7 @@
#define DIS_SAMPLE_RATE_74_25 74250
#define DIS_SAMPLE_RATE_148_5 148500
#define HAD_REG_WIDTH 0x08
-#define HAD_MAX_HW_BUFS 0x04
#define HAD_MAX_DIP_WORDS 16
-#define INTEL_HAD "HdmiLpeAudio"
/* DP Link Rates */
#define DP_2_7_GHZ 270000
@@ -112,72 +109,34 @@ enum hdmi_ctrl_reg_offset {
AUD_HDMIW_INFOFR = 0x68, /* v2 */
};
-/*
- * CEA speaker placement:
- *
- * FL FLC FC FRC FR
- *
- * LFE
- *
- * RL RLC RC RRC RR
- *
- * The Left/Right Surround channel _notions_ LS/RS in SMPTE 320M
- * corresponds to CEA RL/RR; The SMPTE channel _assignment_ C/LFE is
- * swapped to CEA LFE/FC.
- */
-enum cea_speaker_placement {
- FL = (1 << 0), /* Front Left */
- FC = (1 << 1), /* Front Center */
- FR = (1 << 2), /* Front Right */
- FLC = (1 << 3), /* Front Left Center */
- FRC = (1 << 4), /* Front Right Center */
- RL = (1 << 5), /* Rear Left */
- RC = (1 << 6), /* Rear Center */
- RR = (1 << 7), /* Rear Right */
- RLC = (1 << 8), /* Rear Left Center */
- RRC = (1 << 9), /* Rear Right Center */
- LFE = (1 << 10), /* Low Frequency Effect */
-};
-
-struct cea_channel_speaker_allocation {
- int ca_index;
- int speakers[8];
-
- /* derived values, just for convenience */
- int channels;
- int spk_mask;
-};
-
-struct channel_map_table {
- unsigned char map; /* ALSA API channel map position */
- unsigned char cea_slot; /* CEA slot value */
- int spk_mask; /* speaker position bit mask */
-};
-
/* Audio configuration */
union aud_cfg {
struct {
u32 aud_en:1;
- u32 layout:1;
+ u32 layout:1; /* LAYOUT[01], see below */
u32 fmt:2;
u32 num_ch:3;
u32 set:1;
u32 flat:1;
u32 val_bit:1;
u32 user_bit:1;
- u32 underrun:1;
- u32 packet_mode:1;
- u32 left_align:1;
- u32 bogus_sample:1;
- u32 dp_modei:1;
+ u32 underrun:1; /* 0: send null packets,
+ * 1: send silence stream
+ */
+ u32 packet_mode:1; /* 0: 32bit container, 1: 16bit */
+ u32 left_align:1; /* 0: MSB bits 0-23, 1: bits 8-31 */
+ u32 bogus_sample:1; /* bogus sample for odd channels */
+ u32 dp_modei:1; /* 0: HDMI, 1: DP */
u32 rsvd:16;
} regx;
u32 regval;
};
-#define AUD_CONFIG_BLOCK_BIT (1 << 7)
#define AUD_CONFIG_VALID_BIT (1 << 9)
#define AUD_CONFIG_DP_MODE (1 << 15)
+#define AUD_CONFIG_CH_MASK 0x70
+#define LAYOUT0 0 /* interleaved stereo */
+#define LAYOUT1 1 /* for channels > 2 */
/* Audio Channel Status 0 Attributes */
union aud_ch_status_0 {
@@ -190,13 +149,22 @@ union aud_ch_status_0 {
u32 ctg_code:8;
u32 src_num:4;
u32 ch_num:4;
- u32 samp_freq:4;
+ u32 samp_freq:4; /* CH_STATUS_MAP_XXX */
u32 clk_acc:2;
u32 rsvd:2;
} regx;
u32 regval;
};
+/* samp_freq values - Sampling rate as per IEC60958 Ver 3 */
+#define CH_STATUS_MAP_32KHZ 0x3
+#define CH_STATUS_MAP_44KHZ 0x0
+#define CH_STATUS_MAP_48KHZ 0x2
+#define CH_STATUS_MAP_88KHZ 0x8
+#define CH_STATUS_MAP_96KHZ 0xA
+#define CH_STATUS_MAP_176KHZ 0xC
+#define CH_STATUS_MAP_192KHZ 0xE
+
/* Audio Channel Status 1 Attributes */
union aud_ch_status_1 {
struct {
@@ -207,6 +175,11 @@ union aud_ch_status_1 {
u32 regval;
};
+#define MAX_SMPL_WIDTH_20 0x0
+#define MAX_SMPL_WIDTH_24 0x1
+#define SMPL_WIDTH_16BITS 0x1
+#define SMPL_WIDTH_24BITS 0x5
+
/* CTS register */
union aud_hdmi_cts {
struct {
@@ -239,6 +212,9 @@ union aud_buf_config {
u32 regval;
};
+#define FIFO_THRESHOLD 0xFE
+#define DMA_FIFO_THRESHOLD 0x7
+
/* Audio Sample Swapping offset */
union aud_buf_ch_swap {
struct {
@@ -255,6 +231,8 @@ union aud_buf_ch_swap {
u32 regval;
};
+#define SWAP_LFE_CENTER 0x00fac4c8 /* octal 76543210 */
+
/* Address for Audio Buffer */
union aud_buf_addr {
struct {
@@ -306,6 +284,9 @@ union aud_info_frame1 {
u32 regval;
};
+#define HDMI_INFO_FRAME_WORD1 0x000a0184
+#define DP_INFO_FRAME_WORD1 0x00441b84
+
/* DIP frame 2 */
union aud_info_frame2 {
struct {
@@ -333,13 +314,15 @@ union aud_info_frame3 {
u32 regval;
};
+#define VALID_DIP_WORDS 3
+
/* AUD_HDMI_STATUS bits */
#define HDMI_AUDIO_UNDERRUN (1U << 31)
#define HDMI_AUDIO_BUFFER_DONE (1U << 29)
/* AUD_HDMI_STATUS register mask */
-#define AUD_CONFIG_MASK_UNDERRUN 0xC0000000
-#define AUD_CONFIG_MASK_SRDBG 0x00000002
-#define AUD_CONFIG_MASK_FUNCRST 0x00000001
+#define AUD_HDMI_STATUS_MASK_UNDERRUN 0xC0000000
+#define AUD_HDMI_STATUS_MASK_SRDBG 0x00000002
+#define AUD_HDMI_STATUSG_MASK_FUNCRST 0x00000001
#endif
