hwmon: Add support for INA3221 Triple Current/Voltage Monitors
Add support for the the INA3221 26v capable, Triple channel,
Bi-Directional, Zero-Drift, Low-/High-Side, Current/Voltage Monitor
with I2C interface.
Signed-off-by: Andrew F. Davis <afd@ti.com>
Signed-off-by: Guenter Roeck <linux@roeck-us.net>
diff --git a/Documentation/hwmon/ina3221 b/Documentation/hwmon/ina3221
new file mode 100644
index 0000000..0ff7485
--- /dev/null
+++ b/Documentation/hwmon/ina3221
@@ -0,0 +1,35 @@
+Kernel driver ina3221
+=====================
+
+Supported chips:
+ * Texas Instruments INA3221
+ Prefix: 'ina3221'
+ Addresses: I2C 0x40 - 0x43
+ Datasheet: Publicly available at the Texas Instruments website
+ http://www.ti.com/
+
+Author: Andrew F. Davis <afd@ti.com>
+
+Description
+-----------
+
+The Texas Instruments INA3221 monitors voltage, current, and power on the high
+side of up to three D.C. power supplies. The INA3221 monitors both shunt drop
+and supply voltage, with programmable conversion times and averaging, current
+and power are calculated host-side from these.
+
+Sysfs entries
+-------------
+
+in[123]_input Bus voltage(mV) channels
+curr[123]_input Current(mA) measurement channels
+shunt[123]_resistor Shunt resistance(uOhm) channels
+curr[123]_crit Critical alert current(mA) setting, activates the
+ corresponding alarm when the respective current
+ is above this value
+curr[123]_crit_alarm Critical alert current limit exceeded
+curr[123]_max Warning alert current(mA) setting, activates the
+ corresponding alarm when the respective current
+ average is above this value.
+curr[123]_max_alarm Warning alert current limit exceeded
+in[456]_input Shunt voltage(uV) for channels 1, 2, and 3 respectively
