[POWERPC] Enable MSI mappings for MPIC
On some Apple machines the HT MSI mappings are not enabled by firmware, so
we need to do it by hand.
We can't use the pci routines as this code runs too early.
Signed-off-by: Michael Ellerman <michael@ellerman.id.au>
Signed-off-by: Paul Mackerras <paulus@samba.org>
diff --git a/arch/powerpc/sysdev/mpic.c b/arch/powerpc/sysdev/mpic.c
index e88bbd5..33ecf89 100644
--- a/arch/powerpc/sysdev/mpic.c
+++ b/arch/powerpc/sysdev/mpic.c
@@ -389,6 +389,50 @@
#endif
}
+#ifdef CONFIG_PCI_MSI
+static void __init mpic_scan_ht_msi(struct mpic *mpic, u8 __iomem *devbase,
+ unsigned int devfn)
+{
+ u8 __iomem *base;
+ u8 pos, flags;
+ u64 addr = 0;
+
+ for (pos = readb(devbase + PCI_CAPABILITY_LIST); pos != 0;
+ pos = readb(devbase + pos + PCI_CAP_LIST_NEXT)) {
+ u8 id = readb(devbase + pos + PCI_CAP_LIST_ID);
+ if (id == PCI_CAP_ID_HT) {
+ id = readb(devbase + pos + 3);
+ if ((id & HT_5BIT_CAP_MASK) == HT_CAPTYPE_MSI_MAPPING)
+ break;
+ }
+ }
+
+ if (pos == 0)
+ return;
+
+ base = devbase + pos;
+
+ flags = readb(base + HT_MSI_FLAGS);
+ if (!(flags & HT_MSI_FLAGS_FIXED)) {
+ addr = readl(base + HT_MSI_ADDR_LO) & HT_MSI_ADDR_LO_MASK;
+ addr = addr | ((u64)readl(base + HT_MSI_ADDR_HI) << 32);
+ }
+
+ printk(KERN_DEBUG "mpic: - HT:%02x.%x %s MSI mapping found @ 0x%lx\n",
+ PCI_SLOT(devfn), PCI_FUNC(devfn),
+ flags & HT_MSI_FLAGS_ENABLE ? "enabled" : "disabled", addr);
+
+ if (!(flags & HT_MSI_FLAGS_ENABLE))
+ writeb(flags | HT_MSI_FLAGS_ENABLE, base + HT_MSI_FLAGS);
+}
+#else
+static void __init mpic_scan_ht_msi(struct mpic *mpic, u8 __iomem *devbase,
+ unsigned int devfn)
+{
+ return;
+}
+#endif
+
static void __init mpic_scan_ht_pic(struct mpic *mpic, u8 __iomem *devbase,
unsigned int devfn, u32 vdid)
{
@@ -480,6 +524,7 @@
goto next;
mpic_scan_ht_pic(mpic, devbase, devfn, l);
+ mpic_scan_ht_msi(mpic, devbase, devfn);
next:
/* next device, if function 0 */
