b44: Set PHY address to NO_PHY if reset fails.
Do a PHY reset to test if there is an active phy and set the PHY address
to B44_PHY_ADDR_NO_PHY in case of an not active phy. This is needed for
the Linksys WRTSL54GS and Asus WL-500W.
This patch was used in OpenWRT for a long time.
Signed-off-by: Hauke Mehrtens <hauke@hauke-m.de>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/b44.c b/drivers/net/b44.c
index 180510e..71fa0be 100644
--- a/drivers/net/b44.c
+++ b/drivers/net/b44.c
@@ -338,7 +338,7 @@
}
}
- return 0;
+ return err;
}
static void __b44_set_flow_ctrl(struct b44 *bp, u32 pause_flags)
@@ -2215,6 +2215,10 @@
*/
b44_chip_reset(bp, B44_CHIP_RESET_FULL);
+ /* do a phy reset to test if there is an active phy */
+ if (b44_phy_reset(bp) < 0)
+ bp->phy_addr = B44_PHY_ADDR_NO_PHY;
+
netdev_info(dev, "Broadcom 44xx/47xx 10/100BaseT Ethernet %pM\n",
dev->dev_addr);
