mmc: core: Only change mode if mmc_select_bus_width() is successful
mmc_select_bus_width() returns bus width (4 or 8) on success or
zero if unsupported. So only change mode if setting the bus width
is successful.
Signed-off-by: Peter Griffin <peter.griffin@linaro.org>
Signed-off-by: Ulf Hansson <ulf.hansson@linaro.org>
diff --git a/drivers/mmc/core/mmc.c b/drivers/mmc/core/mmc.c
index 900b9f9..ccab9bb 100644
--- a/drivers/mmc/core/mmc.c
+++ b/drivers/mmc/core/mmc.c
@@ -1334,7 +1334,7 @@
* switch to HS200 mode if bus width is set successfully.
*/
err = mmc_select_bus_width(card);
- if (err >= 0) {
+ if (err > 0) {
val = EXT_CSD_TIMING_HS200 |
card->drive_strength << EXT_CSD_DRV_STR_SHIFT;
err = __mmc_switch(card, EXT_CSD_CMD_SET_NORMAL,
@@ -1642,7 +1642,7 @@
} else if (mmc_card_hs(card)) {
/* Select the desired bus width optionally */
err = mmc_select_bus_width(card);
- if (err >= 0) {
+ if (err > 0) {
err = mmc_select_hs_ddr(card);
if (err)
goto free_card;
